|
Hello,
In one of our project we need to connect one IMX 27
based baord which ahs a internal FEC controller & an MPC 8323RDb baord which
has a Built in Network controller.
We need to connect the IMX27 based board to MPC
board thro cross cable & MPC baord has wlan AP card .
Basically we want to communicate from IMX27 to
wireless network. Hence we are planning to make follwoing arranage ment as given
in the attached ppt & we use
bridge as per this site
http://www.linuxfoundation.org/en/Net:Bridge If we use external network controller we can
acheive teh communication as desired by bridging ra0 ( wlan ) &
eth0 on MPC baord . BUt if we use IMX27 internal FEC controller we are unable to
acheive the communication by bridging the eth0 & ra0 on MPC baord.
Anything setting to be done on the IMX 27 board? (
kernel configs, or specofoc protocol related configs?)
If we don't do teh bridging on the MPC side, we can
communicate directly from IMX27 to MPC thor cross connection ( without
bridging)
Can we get some inputs? has anybody tried similarly
earlier ?
Regards
Praveen
|
_______________________________________________ Bridge mailing list Bridge@xxxxxxxxxxxxxxxxxxxxxxxxxx https://lists.linux-foundation.org/mailman/listinfo/bridge
