On Wed, 3 Sep 2003 16:56:06 +0200 Hannes Schulz <schulz@xxxxxxxxxxx> wrote: > >Could the problem be that the e100 can do IP receive checksumming on > >the board, > >but the eepro driver doesn't enable it. When the board is doing checksum > >offload, then the csum field isn't set. > > > >Please try disabling receive checksumming on the e100 driver > > > > modprobe e100 XsumRX=0 > > > >If this is the problem, it exists both 2.4 and 2.6. > > If have just booted into 2.6.0-test4. Unplugging works, but the > console is flooded with: > last-F IN=br0 OUT=br0 PHYSIN=eth1 PHYSOUT=eth0 SRC=10.96.96.25 DST=10.96.96.255 > > [last-F ist the last rule in my FORWARDING iptable and does log+drop] > > Obviously I must allow forwarding br0 <=> br0. > > While I am writing this the counter on the FORWARDING rule -i br0 -o > br0 -j ACCEPT has reaches 2000+ packets with eth0 unplugged and the > kernel ist still running. > > > In both 2.4.22 and 2.6.0-test4 all of netfilter and advanced routing > ist set to M. In 2.6.0-test4 this includes ebtables. > > > Hope that helps > > Hannes You enabled NETFILTER_DEBUG in your config
