Re: [PATCH v2 17/20] extcon: intel-cht-wc: Support devs with Micro-B / USB-2 only Type-C connectors

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Sun, Nov 14, 2021 at 7:04 PM Hans de Goede <hdegoede@xxxxxxxxxx> wrote:
>
> So far the extcon-intel-cht-wc code has only been tested on devices with
> a Type-C connector with USB-PD, USB3 (superspeed) and DP-altmode support
> through a FUSB302 Type-C controller.
>
> Some devices with the intel-cht-wc PMIC however come with an USB-micro-B
> connector, or an USB-2 only Type-C connector without USB-PD.
>
> Which device-model we are running on can be identified with the new
> intel_cht_wc_get_model() helper and on models without a Type-C controller
> the extcon code must control the Vbus 5V boost converter and the USB role
> switch depending on the detected cable-type.

...

>  config EXTCON_INTEL_CHT_WC
>         tristate "Intel Cherrytrail Whiskey Cove PMIC extcon driver"
> -       depends on INTEL_SOC_PMIC_CHTWC

> +       depends on INTEL_SOC_PMIC_CHTWC && USB_SUPPORT

Having these two in one expression sounds a bit alogical to me, can
you just add a separate "depends on"?

> +       select USB_ROLE_SWITCH

...

> +       if (ext->vbus_boost && ext->vbus_boost_enabled != enable) {
> +               if (enable)
> +                       ret = regulator_enable(ext->vbus_boost);
> +               else
> +                       ret = regulator_disable(ext->vbus_boost);

Redundant blank line here (but it's up to you)

> +               if (ret == 0)
> +                       ext->vbus_boost_enabled = enable;
> +               else
> +                       dev_err(ext->dev, "Error updating Vbus boost regulator: %d\n", ret);

Why not a traditional pattern, i.e. error handling first?

> +       }

...

> +/* Some boards require controlling the role-sw and vbus based on the id-pin */

Vbus ? VBUS? Here and there the inconsistency of some terms...

...

> +       ext->vbus_boost = devm_regulator_get_optional(ext->dev, "vbus");
> +       if (IS_ERR(ext->vbus_boost)) {
> +               ret = PTR_ERR(ext->vbus_boost);
> +               if (ret == -ENODEV)
> +                       ret = -EPROBE_DEFER;
> +
> +               return dev_err_probe(ext->dev, ret, "getting vbus regulator");

Can be also written as

    if (PTR_ERR(ext->vbus_boost) == -ENODEV ||
PTR_ERR(ext->vbus_boost) == -EPROBE_DEFER)
        return dev_err_probe(ext->dev, -EPROBE_DEFER, "getting vbus regulator");

    return PTR_ERR(ext->vbus_boost);

but up to you.

> +       }

-- 
With Best Regards,
Andy Shevchenko



[Index of Archives]     [Linux ARM Kernel]     [Linux ARM]     [Linux Omap]     [Fedora ARM]     [IETF Annouce]     [Security]     [Bugtraq]     [Linux OMAP]     [Linux MIPS]     [ECOS]     [Asterisk Internet PBX]     [Linux API]

  Powered by Linux