Hi,
We're working with a new consumer MiniPC based on AMD E1-7010.
It fails to boot Linux when booting in EFI mode - it hangs with
nothing on screen. earlycon=efifb doesn't show any output.
Looking closer, I was able to confirm that we reach EFI
ExitBootServices() via efi_printk in the efi stub. But you can't use
EFI's console functionality after that point, so I then resorted to
inserting calls to:
idt_invalidate(NULL); __asm__ __volatile__("int3");
throughout the early boot code that follows in order to force a system
reset. That way I could deduce if execution was reaching that point
(system reset) or not (system hang as before). As a side-question I'd
be curious if there is any better way to debug such early boot
failures on consumer x86 hardware without a serial port...
Anyway, the system freeze occurs in parse_setup_data(), specifically:
data = early_memremap(pa_data, sizeof(*data));
data_len = data->len + sizeof(struct setup_data);
Dereferencing data->len causes the system to hang. I presume it
triggers an exception handler due to some kind of invalid memory
access.
By returning early in that function, boot continues basically fine. So
I could then log the details: pa_data has value 0x892bb018 and
early_memremap returns address 0xffffffffff200018. Accessing just a
single byte at that address causes the system hang.
This original pa_data value (from boot_params.hdr.setup_data) was set
by the EFI stub in setup_efi_pci(). I confirmed that the same
0x892bb018 value is set there, it is not being corrupted along the
way.
Any suggestions for how to diagnose further?
dmesg output:
https://gist.github.com/dsd/199bed7b590e90efdf73f9f6384ca551
Thanks
Daniel
