dmesg
[ 13.177367] cx23885 driver version 0.0.2 loaded[ 13.177862] ACPI: PCI Interrupt Link [APC8] enabled at IRQ 16[ 13.177873] cx23885 0000:04:00.0: PCI INT A -> Link[APC8] -> GSI 16 (level, low) -> IRQ 16[ 13.178014] CORE cx23885[0]: subsystem: 1858:e800, board: Compro VideoMate E800 [card=18,autodetected][ 13.373933] cx25840 2-0044: cx25 0-21 found @ 0x88 (cx23885[0])[ 13.378062] cx25840 2-0044: firmware: requesting v4l-cx23885-avcore-01.fw[ 13.387800] HDA Intel 0000:00:09.0: power state changed by ACPI to D0[ 13.388243] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22[ 13.388248] HDA Intel 0000:00:09.0: PCI INT A -> Link[AAZA] -> GSI 22 (level, low) -> IRQ 22[ 13.388299] HDA Intel 0000:00:09.0: setting latency timer to 64[ 14.020387] cx25840 2-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)[ 14.026309] cx23885_dvb_register() allocating 1 frontend(s)[ 14.026313] cx23885[0]: cx23885 based dvb card[ 14.102491] xc2028 1-0061: creating new instance[ 14.102495] xc2028 1-0061: type set to XCeive xc2028/xc3028 tuner[ 14.102501] DVB: registering new adapter (cx23885[0])[ 14.102506] DVB: registering adapter 0 frontend 0 (Zarlink ZL10353 DVB-T)...[ 14.102855] cx23885_dev_checkrevision() Hardware revision = 0xb0[ 14.102863] cx23885[0]/0: found at 0000:04:00.0, rev: 2, irq: 16, latency: 0, mmio: 0xef600000[ 14.102871] cx23885 0000:04:00.0: setting latency timer to 64
w_scan version 20081106Info: using DVB adapter auto detection. Found DVB-T frontend. Using adapter /dev/dvb/adapter0/frontend0-_-_-_-_ Getting frontend capabilities-_-_-_-_ frontend Zarlink ZL10353 DVB-T supportsINVERSION_AUTOQAM_AUTOTRANSMISSION_MODE_AUTOGUARD_INTERVAL_AUTOHIERARCHY_AUTOFEC_AUTO-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_-_ 177500: 184500: 191500: 198500: 205500: 212500: 219500: 226500: 474000: 482000: 490000: 498000: 506000: 514000: 522000: 530000: 538000: 546000: 554000: 562000: 570000: 578000: 586000: 594000: 602000: 610000: 618000: 626000: 634000: signal ok (I999B8C999D999M999T999G999Y999)642000: 650000: signal ok (I999B8C999D999M999T999G999Y999)658000: 666000: 674000: 682000: 690000: 698000: 706000: 714000: signal ok (I999B8C999D999M999T999G999Y999)722000: 730000: 738000: 746000: 754000: 762000: 770000: 778000: 786000: 794000: 802000: 810000: 818000: 826000: 834000: 842000: 850000: 858000: tune to: :634000:I999B8C999D999M999T999G999Y999:T:27500:Info: filter timeout pid 0x0011Info: filter timeout pid 0x0000Info: filter timeout pid 0x0010tune to: :650000:I999B8C999D999M999T999G999Y999:T:27500:Info: filter timeout pid 0x0011Info: filter timeout pid 0x0000Info: filter timeout pid 0x0010tune to: :714000:I999B8C999D999M999T999G999Y999:T:27500:Info: filter timeout pid 0x0011Info: filter timeout pid 0x0000Info: filter timeout pid 0x0010dumping lists (0 services)Done.
Patch for add support Compro Videomate e800 (dvt-t part only)
diff -Naur a/linux/Documentation/video4linux/CARDLIST.cx23885 b/linux/Documentation/video4linux/CARDLIST.cx23885--- a/linux/Documentation/video4linux/CARDLIST.cx23885 2009-04-26 15:30:18.000000000 +0300+++ b/linux/Documentation/video4linux/CARDLIST.cx23885 2009-04-29 18:19:45.561827543 +0300@@ -16,3 +16,4 @@ 15 -> TeVii S470 [d470:9022] 16 -> DVBWorld DVB-S2 2005 [0001:2005] 17 -> NetUP Dual DVB-S2 CI [1b55:2a2c]+ 18 -> Compro VideoMate E800 [1858:e800]diff -Naur a/linux/drivers/media/video/cx23885/cx23885-cards.c b/linux/drivers/media/video/cx23885/cx23885-cards.c--- a/linux/drivers/media/video/cx23885/cx23885-cards.c 2009-04-26 15:30:18.000000000 +0300+++ b/linux/drivers/media/video/cx23885/cx23885-cards.c 2009-04-29 18:19:45.561827543 +0300@@ -182,6 +182,10 @@ .portb = CX23885_MPEG_DVB, .portc = CX23885_MPEG_DVB, },+ [CX23885_BOARD_COMPRO_VIDEOMATE_E800] = {+ .name = "Compro VideoMate E800",+ .portc = CX23885_MPEG_DVB,+ }, }; const unsigned int cx23885_bcount = ARRAY_SIZE(cx23885_boards); @@ -281,6 +285,10 @@ .subvendor = 0x1b55, .subdevice = 0x2a2c, .card = CX23885_BOARD_NETUP_DUAL_DVBS2_CI,+ }, {+ .subvendor = 0x1858,+ .subdevice = 0xe800,+ .card = CX23885_BOARD_COMPRO_VIDEOMATE_E800, }, }; const unsigned int cx23885_idcount = ARRAY_SIZE(cx23885_subids);@@ -435,6 +443,7 @@ case CX23885_BOARD_HAUPPAUGE_HVR1500Q: case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:+ case CX23885_BOARD_COMPRO_VIDEOMATE_E800: /* Tuner Reset Command */ bitmask = 0x04; break;@@ -576,6 +585,7 @@ break; case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:+ case CX23885_BOARD_COMPRO_VIDEOMATE_E800: /* GPIO-2 xc3028 tuner reset */ /* The following GPIO's are on the internal AVCore (cx25840) */@@ -724,6 +734,7 @@ case CX23885_BOARD_HAUPPAUGE_HVR1400: case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:+ case CX23885_BOARD_COMPRO_VIDEOMATE_E800: default: ts2->gen_ctrl_val = 0xc; /* Serial bus + punctured clock */ ts2->ts_clk_en_val = 0x1; /* Enable TS_CLK */@@ -740,6 +751,7 @@ case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: case CX23885_BOARD_COMPRO_VIDEOMATE_E650F: case CX23885_BOARD_NETUP_DUAL_DVBS2_CI:+ case CX23885_BOARD_COMPRO_VIDEOMATE_E800: dev->sd_cx25840 = v4l2_i2c_new_subdev(&dev->v4l2_dev, &dev->i2c_bus[2].i2c_adap, "cx25840", "cx25840", 0x88 >> 1);diff -Naur a/linux/drivers/media/video/cx23885/cx23885-dvb.c b/linux/drivers/media/video/cx23885/cx23885-dvb.c--- a/linux/drivers/media/video/cx23885/cx23885-dvb.c 2009-04-26 15:30:18.000000000 +0300+++ b/linux/drivers/media/video/cx23885/cx23885-dvb.c 2009-04-29 18:19:45.565435068 +0300@@ -565,6 +565,7 @@ } case CX23885_BOARD_LEADTEK_WINFAST_PXDVR3200_H: case CX23885_BOARD_COMPRO_VIDEOMATE_E650F:+ case CX23885_BOARD_COMPRO_VIDEOMATE_E800: i2c_bus = &dev->i2c_bus[0]; fe0->dvb.frontend = dvb_attach(zl10353_attach,diff -Naur a/linux/drivers/media/video/cx23885/cx23885.h b/linux/drivers/media/video/cx23885/cx23885.h--- a/linux/drivers/media/video/cx23885/cx23885.h 2009-04-26 15:30:18.000000000 +0300+++ b/linux/drivers/media/video/cx23885/cx23885.h 2009-04-29 18:19:45.565435068 +0300@@ -72,6 +72,7 @@ #define CX23885_BOARD_TEVII_S470 15 #define CX23885_BOARD_DVBWORLD_2005 16 #define CX23885_BOARD_NETUP_DUAL_DVBS2_CI 17+#define CX23885_BOARD_COMPRO_VIDEOMATE_E800 18 /* Currently unsupported by the driver: PAL/H, NTSC/Kr, SECAM B/G/H/LC */ #define CX23885_NORMS (\-------- Завершение пересылаемого сообщения --------
_______________________________________________linux-dvb users mailing listFor V4L/DVB development, please use instead linux-media@xxxxxxxxxxxxxxxxxxxxxxxx@linuxtv.orghttp://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
