Tomasz Chmielewski schrieb:
> I have a DVB USB device which identifies as:
>
> # lsusb
> Bus 001 Device 006: ID 04ca:f001 Lite-On Technology Corp.
>
>
> Randomly, upon machine bootup, it is not detected properly ("no frontend was attached"):
>
> usb 1-6: new high speed USB device using ehci_hcd and address 4
> usb 1-6: configuration #1 chosen from 1 choice
> dvb-usb: found a 'LITE-ON USB2.0 DVB-T Tuner' in warm state.
> dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
> DVB: registering new adapter (LITE-ON USB2.0 DVB-T Tuner)
> dvb-usb: no frontend was attached by 'LITE-ON USB2.0 DVB-T Tuner'
> input: IR-receiver inside an USB DVB receiver as /class/input/input6
> dvb-usb: schedule remote query interval to 150 msecs.
> dvb-usb: LITE-ON USB2.0 DVB-T Tuner successfully initialized and connected.
>
>
> As a result, using DVB is impossible until I plug the device out
> and plug it in again.
Does not work here.
>
> This is the only solution to bring it back to life - if I remove
> DVB modules and insert them again, I get:
>
> dvb-usb: bulk message failed: -22 (1/2)
> dvb-usb: bulk message failed: -22 (1/-150651080)
> dvb-usb: bulk message failed: -22 (1/662)
> dvb-usb: bulk message failed: -22 (1/1024)
> dvb-usb: bulk message failed: -22 (1/2)
>
>
> Are there any "better" solutions to that, other then re-inserting the USB device?
> If not, what could be the cause of it?
>
> I use Linux kernel 2.6.28.
>
>
http://www.linuxtv.org/pipermail/linux-dvb/2009-January/031165.html
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
