On Sun, 2009-01-04 at 09:28 -0600, Eric Bauer wrote: > Hello, > > I'm trying to set up my new Happaugue HVR-1600 card. During the scan, > II get several minutes of output on the screen complaining about tuning > failures, These are normal when no service is detected on those freqs. > and then I get the following message: > > start filter:1338: ERROR: ioctl DMX_SET_FILTER failed: 6 No such device > or address Hmmm. New one one me, I'll have to investigate. What specific tool, version and command line arguments are you using? > I have to kill the scan with a control-c at this point. Can anyone give > me some advice with this problem? Make sure you are using the latest cx18 driver from: http://linuxtv.og/hg/v4l-dvb versions older than v1.0.4 of the cx18 driver have problems dealing with the occasional PCI bus error. Instructions can be found here: http://www.ivtvdriver.org/index.php/Cx18 Make sure you have a good clean signal coming in: http://www.ivtvdriver.org/index.php/Howto:Improve_signal_quality Regards, Andy > Thanks, > > Eric _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
