Hi all, There is one problem with that driver revision 2.8: What you need to reproduce the problem: - a channels.conf with FTA channels only - the technisat card Revision 2.8 as the only card in your system - xine or mplayer - mtt and / or dvbrowse, which are essential parts of Gerd Knorr's xawtv-4.0 pre which you can download here: http://dl.bytesex.org/cvs- snapshots/xawtv-20081014-100645.tar.gz You can reproduce the problem with the following procedure: 1. Either start mplayer dvb:// or xine dvb:// (the "master application") 2. Start mtt after successfully compiling xawtv-4.0 pre (the "slave application") Then please zap on / change channel using mplayer or xine. Under normal conditions mtt should stop now and wait as "slave application" for the "master application" to tune a new channel. If that new channel has been tuned correctly mtt should continue and show the new videotext. But what happens instead is the following: mtt stops and waits for the new channel, but for unknown reasons the new channel is not being tuned. The consequence are the typical timeout-based errors known from xine or mplayer. Zapping is only successful if mtt as videotext application is not involved at all parallely. Question: Can someone please reproduce this problem / error? Can someone please offer a fix for that problem? A thousand thanks sinter _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
