Helmut Auer schrieb: > Hi, > > I have a Geniatech PCI DVB-s with CX24123/CX24109. > This card cannot zap to the german ARD transponder, all other channels > are running fine. > The card runs fine under windows . > dmesg shows at loading: > > cx88/0: cx2388x v4l2 driver version 0.0.6 loaded > ACPI: PCI Interrupt 0000:01:09.0[A] -> Link [LNKC] -> GSI 10 (level, > low) -> IRQ 10 > cx88[0]: subsystem: 14f1:0084, board: Geniatech DVB-S [card=52,autodetected] > cx88[0]: TV tuner type 4, Radio tuner type -1 > cx88[0]/0: found at 0000:01:09.0, rev: 5, irq: 10, latency: 165, mmio: > 0xfc000000 > cx88[0]/0: registered device video0 [v4l2] > cx88[0]/0: registered device vbi0 > cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded > cx88[0]/2: cx2388x 8802 Driver Manager > ACPI: PCI Interrupt 0000:01:09.2[A] -> Link [LNKC] -> GSI 10 (level, > low) -> IRQ 10 > cx88[0]/2: found at 0000:01:09.2, rev: 5, irq: 10, latency: 64, mmio: > 0xfd000000 > cx88/2: cx2388x dvb driver version 0.0.6 loaded > cx88/2: registering cx8802 driver, type: dvb access: shared > cx88[0]/2: subsystem: 14f1:0084, board: Geniatech DVB-S [card=52] > cx88[0]/2: cx2388x based DVB/ATSC card > CX24123: detected CX24123 > DVB: registering new adapter (cx88[0]) > DVB: registering frontend 0 (Conexant CX24123/CX24109)... > > and when the error occurs: > > cx88[0]: irq mpeg [0x100000] ts_err?* > cx88[0]/2-mpeg: general errors: 0x00100000 > > Any hints where I can tune some parameters ? > > P.S. The problem occurs with current v4l-hg and also with a 1 year old hg snapshot. -- Helmut Auer, helmut@xxxxxxxxxxxxx _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
