I'm keeping close track of this. I've got the Australian/European version of the card.
Does this mean once analog is working the composite input may work as well?
On Fri Sep 12 11:51 , "Tim Lucas"
Brief summary: Trying to get analog working on a DViCO FusionHDTV7 Dual ExpressIt was suggested that I use the ~stoth/cx23885-audio branch and load the card as a HVR1500.
Since nothing was working, I decided to update to the latest kernel (and therefore mythbuntu 8.1)Although the card still didn't work, I was getting better results. dmesg said
[ 11.224568] cx23885[0]: i2c bus 0 registered[ 11.224609] cx23885[0]: i2c bus 1 registered[ 11.224632] cx23885[0]: i2c bus 2 registered[ 11.251024] tveeprom 2-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom.[ 11.251026] cx23885[0]: warning: unknown hauppauge model #0[ 11.251027] cx23885[0]: hauppauge eeprom: model=0[ 11.268639] cx25840' 4-0044: cx25 0-21 found @ 0x88 (cx23885[0])[ 11.283305] tuner' 2-0064: chip found @ 0xc8 (cx23885[0])[ 11.285887] tuner' 3-0064: chip found @ 0xc8 (cx23885[0])[ 11.288377] cx23885[0]/0: registered device video0 [v4l2][ 11.288653] cx23885[0]/1: registered ALSA audio device[ 11.288658] tuner' 3-0064: tuner type not set[ 11.292131] firmware: requesting v4l-cx23885-avcore-01.fw[ 11.310299] cx25840' 4-0044: unable to open firmware v4l-cx23885-avcore-01.fw[ 11.324551] cx23885[0]: cx23885 based dvb card[ 11.348947] cx23885[0]: frontend initialization failed[ 11.348949] cx23885_dvb_register() dvb_register failed err = -1[ 11.348951] cx23885_dev_setup() Failed to register dvb on VID_C[ 11.348955] cx23885_dev_checkrevision() Hardware revision = 0xb0[ 11.348960] cx23885[0]/0: found at 0000:08:00.0, rev: 2, irq: 16, latency: 0, mmio: 0xfd800000[ 11.348966] cx23885 0000:08:00.0: setting latency timer to 64[ 11.349304] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22[ 11.349308] HDA Intel 0000:00:10.1: PCI INT B -> Link[AAZA] -> GSI 22 (level, low) -> IRQ 22[ 11.349322] HDA Intel 0000:00:10.1: setting latency timer to 64[ 11.382833] hda_codec: Unknown model for ALC883, trying auto-probe from BIOS...[ 12.055790] lp0: using parport0 (interrupt-driven).[ 12.326401] Adding 6040400k swap on /dev/sda5. Priority:-1 extents:1 across:6040400k[ 13.009799] EXT3 FS on sda1, internal journal[ 14.162071] type=1505 audit(1221183219.263:2): operation="profile_load" name="/usr/sbin/mysqld" name2="default" pid=4549[ 14.370696] ip_tables: (C) 2000-2006 Netfilter Core Team[ 15.464191] ACPI: WMI: Mapper loaded[ 18.424988] warning: `avahi-daemon' uses 32-bit capabilities (legacy support in use)[ 19.203038] NET: Registered protocol family 10[ 19.203387] lo: Disabled Privacy Extensions[ 29.299688] tuner' 3-0064: tuner type not set[ 29.307835] tuner' 3-0064: tuner type not set[ 32.729350] mtrr: base(0xf7000000) is not aligned on a size(0xe00000) boundary[ 34.762892] NET: Registered protocol family 17[ 44.712012] eth0: no IPv6 routers present
This made me think that I should go out and find v4l-cx23885-avcore-01.fw.I found it at http://www.steventoth.net/linux/hvr1800/
I loaded this firmware too. New results:[ 11.087605] cx23885 driver version 0.0.1 loaded[ 11.088234] ACPI: PCI Interrupt Link [APC6] enabled at IRQ 16[ 11.088237] cx23885 0000:08:00.0: PCI INT A -> Link[APC6] -> GSI 16 (level, low) -> IRQ 16[ 11.088311] CORE cx23885[0]: subsystem: 18ac:d618, board: Hauppauge WinTV-HVR1500 [card=6,insmod option][ 11.196069] cx23885[0]: i2c bus 0 registered[ 11.196109] cx23885[0]: i2c bus 1 registered[ 11.196144] cx23885[0]: i2c bus 2 registered[ 11.222543] tveeprom 2-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom.[ 11.222545] cx23885[0]: warning: unknown hauppauge model #0[ 11.222546] cx23885[0]: hauppauge eeprom: model=0[ 11.232371] cx25840' 4-0044: cx25 0-21 found @ 0x88 (cx23885[0])[ 11.245763] tuner' 2-0064: chip found @ 0xc8 (cx23885[0])[ 11.248348] tuner' 3-0064: chip found @ 0xc8 (cx23885[0])[ 11.250432] cx23885[0]/0: registered device video0 [v4l2][ 11.250696] cx23885[0]/1: registered ALSA audio device[ 11.250700] tuner' 3-0064: tuner type not set[ 11.254199] firmware: requesting v4l-cx23885-avcore-01.fw[ 11.876323] cx25840' 4-0044: loaded v4l-cx23885-avcore-01.fw firmware (16382 bytes)[ 11.890444] cx23885[0]: cx23885 based dvb card[ 11.920769] cx23885[0]: frontend initialization failed[ 11.920771] cx23885_dvb_register() dvb_register failed err = -1[ 11.920773] cx23885_dev_setup() Failed to register dvb on VID_C[ 11.920777] cx23885_dev_checkrevision() Hardware revision = 0xb0[ 11.920783] cx23885[0]/0: found at 0000:08:00.0, rev: 2, irq: 16, latency: 0, mmio: 0xfd800000[ 11.920788] cx23885 0000:08:00.0: setting latency timer to 64[ 11.921128] ACPI: PCI Interrupt Link [AAZA] enabled at IRQ 22[ 11.921132] HDA Intel 0000:00:10.1: PCI INT B -> Link[AAZA] -> GSI 22 (level, low) -> IRQ 22[ 11.921147] HDA Intel 0000:00:10.1: setting latency timer to 64[ 11.954833] hda_codec: Unknown model for ALC883, trying auto-probe from BIOS...[ 13.052435] lp0: using parport0 (interrupt-driven).[ 13.323879] Adding 6040400k swap on /dev/sda5. Priority:-1 extents:1 across:6040400k[ 14.006491] EXT3 FS on sda1, internal journal[ 15.167174] type=1505 audit(1221184067.272:2): operation="profile_load" name="/usr/sbin/mysqld" name2="default" pid=4590[ 15.334061] ip_tables: (C) 2000-2006 Netfilter Core Team[ 16.444201] ACPI: WMI: Mapper loaded[ 19.463314] warning: `avahi-daemon' uses 32-bit capabilities (legacy support in use)[ 20.171391] NET: Registered protocol family 10[ 20.171801] lo: Disabled Privacy Extensions[ 29.432385] tuner' 3-0064: tuner type not set[ 29.440692] tuner' 3-0064: tuner type not set[ 34.560243] NET: Registered protocol family 17[ 44.123339] mtrr: base(0xf7000000) is not aligned on a size(0xe00000) boundary[ 45.156509] eth0: no IPv6 routers present
I feel like I am getting closer, but I still cannot tune channels. Any help would be appreciated.
--
--Tim
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
