On Fri, Sep 5, 2008 at 7:31 AM, Tim Lucas <lucastim@xxxxxxxxx> wrote:
> > On Sat, Sep 6, 2008 at 2:24 PM, Tim Lucas <lucastim@xxxxxxxxx> wrote:
> > Did you get this message? I didn't know if you or anyone else had any insight into this problem.
I am still trying to resolve this issue. Loading the HVR1500 driver does not work. You can check the dmesg above and I think the problems start at the line
[ 589.382427] tveeprom 5-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom.
I would still like to try to get analog support working for my DViCO FusionHDTV7 Dual Express. This seemed like my best prospect.
--
--Tim
> Why doesn't the driver load if you force it with card=X? What does dmesg show?
>
> - SteveI followed your instructions modprobe cx23885 debug=1 says operation not permitted
Then I tried sudo modprobe cx23885 debug=1 and it says the process was killed
This is the output from dmeg.589.243831] cx23885: no version for "snd_pcm_new" found: kernel tainted.
[ 589.245284] cx23885 driver version 0.0.1 loaded
[ 589.245628] ACPI: PCI Interrupt Link [APC6] enabled at IRQ 16
[ 589.245632] ACPI: PCI Interrupt 0000:08:00.0[A] -> Link [APC6] -> GSI 16 (level, low) -> IRQ 16
[ 589.245750] cx23885[0]/0: cx23885_dev_setup() Memory configured for PCIe bridge type 885
[ 589.245752] cx23885[0]/0: cx23885_init_tsport(portno=2)
[ 589.245759] CORE cx23885[0]: subsystem: 18ac:d618, board: Hauppauge WinTV-HVR1500 [card=6,insmod option]
[ 589.245761] cx23885[0]/0: cx23885_pci_quirks()
[ 589.245763] cx23885[0]/0: cx23885_dev_setup() tuner_type = 0x47 tuner_addr = 0x61
[ 589.245765] cx23885[0]/0: cx23885_dev_setup() radio_type = 0x0 radio_addr = 0x0
[ 589.245766] cx23885[0]/0: cx23885_reset()
[ 589.345825] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [VID A]
[ 589.345837] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch2]
[ 589.345838] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS1 B]
[ 589.345850] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch4]
[ 589.345852] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch5]
[ 589.345853] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TS2 C]
589.345866] cx23885[0]/0: cx23885_sram_channel_setup() Configuring channel [TV Audio]
[ 589.345880] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch8]
[ 589.345882] cx23885[0]/0: cx23885_sram_channel_setup() Erasing channel [ch9]
[ 589.355776] cx23885[0]: i2c bus 0 registered
[ 589.355793] cx23885[0]: i2c bus 1 registered
[ 589.355810] cx23885[0]: i2c bus 2 registered
[ 589.382427] tveeprom 5-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom.
[ 589.382431] cx23885[0]: warning: unknown hauppauge model #0
[ 589.382432] cx23885[0]: hauppauge eeprom: model=0
[ 589.388510] cx25840' 7-0044: cx25 0-21 found @ 0x88 (cx23885[0])
[ 589.395552] tuner' 5-0064: chip found @ 0xc8 (cx23885[0])
[ 589.398231] tuner' 6-0064: chip found @ 0xc8 (cx23885[0])
[ 589.400298] cx23885[0]/0: registered device video0 [v4l2]
[ 589.400351] Unable to handle kernel NULL pointer dereference at 0000000000000008 RIP:
[ 589.400353] [<ffffffff881f5f89>] :snd:snd_device_new+0x59/0xb0
[ 589.400363] PGD 7105a067 PUD 7c727067 PMD 0
[ 589.400366] Oops: 0002 [1] SMP
[ 589.400368] CPU 0
[ 589.400369] Modules linked in: tuner cx25840 cx23885(F) af_packet ipv6 cpufreq_ondemand cpufreq_stats cpuf
q_userspace freq_table cpufreq_powersave cpufreq_conservative video output container dock sbs sbshc battery ipt
able_filter ip_tables x_tables ac sbp2 lp compat_ioctl32 nvidia(P) videodev v4l1_compat cx2341x videobuf_dma_sg
v4l2_common btcx_risc tveeprom videobuf_dvb dvb_core videobuf_core snd_hda_intel snd_pcm_oss snd_mixer_oss snd
_pcm snd_page_alloc snd_hwdep snd_seq_dummy snd_seq_oss snd_seq_midi snd_rawmidi snd_seq_midi_event snd_seq ser
io_raw snd_timer snd_seq_device psmouse snd button i2c_nforce2 i2c_core parport_pc parport shpchp pci_hotplug e
vdev soundcore pcspkr ext3 jbd mbcache usbhid hid sd_mod sg sr_mod cdrom sata_nv ehci_hcd ohci1394 ohci_hcd pat
a_acpi pata_amd usbcore ieee1394 forcedeth ata_generic libata scsi_mod thermal processor fan fbcon tileblit fon
t bitblit softcursor fuse
[ 589.400408] Pid: 17811, comm: modprobe Tainted: PF 2.6.24-21-generic #1
[ 589.400409] RIP: 0010:[<ffffffff881f5f89>] [<ffffffff881f5f89>] :snd:snd_device_new+0x59/0xb0
[ 589.400416] RSP: 0018:ffff810073235aa8 EFLAGS: 00010282
[ 589.400417] RAX: 0000000000000000 RBX: ffffffff88c7dd20 RCX: 0000000000000000
[ 589.400418] RDX: ffff810071048e40 RSI: 0000000000000000 RDI: ffff810071048e80
[ 589.400420] RBP: 0000000000001003 R08: 0000000000000000 R09: ffff810071048e40
[ 589.400421] R10: 0000000000000000 R11: ffffffff803bcc30 R12: ffff81007212d000
[ 589.400423] R13: ffffffff8821a620 R14: ffff810073235b20 R15: ffffffff88265e48
[ 589.400424] FS: 00007f379fe496e0(0000) GS:ffffffff805b9000(0000) knlGS:0000000000000000
[ 589.400426] CS: 0010 DS: 0000 ES: 0000 CR0: 000000008005003b
[ 589.400427] CR2: 0000000000000008 CR3: 0000000073137000 CR4: 00000000000006e0
[ 589.400429] DR0: 0000000000000000 DR1: 0000000000000000 DR2: 0000000000000000
[ 589.400430] DR3: 0000000000000000 DR6: 00000000ffff0ff0 DR7: 0000000000000400
[ 589.400432] Process modprobe (pid: 17811, threadinfo ffff810073234000, task ffff81007c53c7e0)
[ 589.400433] Stack: ffff81007212d000 ffff81007212d000 ffff810073235b08 ffffffff88c7dd20
[ 589.400436] ffffffff88266648 ffffffff88215128 ffff81007b6d1e58 ffff81007212d400
[ 589.400439] 0000000000000018 ffff81007212d458 0000000000000001 ffffffff88264c12
[ 589.400441] Call Trace:
[ 589.400448] [<ffffffff88215128>] :snd_timer:snd_timer_new+0x128/0x180
[ 589.400457] [<ffffffff88264c12>] :snd_pcm:snd_pcm_timer_init+0x52/0x1a0
[ 589.400465] [<ffffffff8825b7dd>] :snd_pcm:snd_pcm_dev_register+0xfd/0x220
[ 589.400470] [<ffffffff802f88a8>] create_proc_entry+0x58/0xa0
[ 589.400480] [<ffffffff881f5c9f>] :snd:snd_device_register_all+0x2f/0x60
[ 589.400487] [<ffffffff881f0b8b>] :snd:snd_card_register+0x3b/0x390
[ 589.400493] [<ffffffff8825b9e3>] :snd_pcm:snd_pcm_new+0xe3/0x140
[ 589.400505] [<ffffffff88c6f306>] :cx23885:cx23885_audio_initdev+0x156/0x1d0
[ 589.400512] [<ffffffff88c66a52>] :cx23885:cx23885_video_register+0x1d2/0x2f0
[ 589.400520] [<ffffffff88c644d0>] :cx23885:cx23885_tuner_callback+0x0/0xf0
[ 589.400526] [<ffffffff881e1f8a>] :i2c_core:i2c_clients_command+0x2a/0xe0
[ 589.400534] [<ffffffff88c6aef7>] :cx23885:cx23885_initdev+0x927/0xb00
[ 589.400537] [<ffffffff8034a172>] kobject_get+0x12/0x20
[ 589.400542] [<ffffffff8035e4b8>] pci_device_probe+0xf8/0x170
[ 589.400548] [<ffffffff803bfd7c>] driver_probe_device+0x9c/0x1b0
[ 589.400552] [<ffffffff803c0049>] __driver_attach+0xc9/0xd0
[ 589.400556] [<ffffffff803bff80>] __driver_attach+0x0/0xd0
[ 589.400558] [<ffffffff803befbd>] bus_for_each_dev+0x4d/0x80
[ 589.400564] [<ffffffff803bf3cc>] bus_add_driver+0xac/0x220
[ 589.400567] [<ffffffff8035e739>] __pci_register_driver+0x69/0xb0
[ 589.400572] [<ffffffff80263e0e>] sys_init_module+0x18e/0x1a90
[ 589.400586] [<ffffffff882f2550>] :videobuf_core:videobuf_mmap_free+0x0/0x40
[ 589.400593] [<ffffffff8020c37e>] system_call+0x7e/0x83
[ 589.400600]
[ 589.400600]
[ 589.400601] Code: 48 89 50 08 48 89 02 48 8d 83 50 01 00 00 48 89 93 50 01 00
[ 589.400607] RIP [<ffffffff881f5f89>] :snd:snd_device_new+0x59/0xb0
[ 589.400613] RSP <ffff810073235aa8>
[ 589.400614] CR2: 0000000000000008
[ 589.400615] ---[ end trace 5a3db5147eff6869 ]---
> > On Sat, Sep 6, 2008 at 2:24 PM, Tim Lucas <lucastim@xxxxxxxxx> wrote:
> > Did you get this message? I didn't know if you or anyone else had any insight into this problem.
[ 589.382427] tveeprom 5-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom.
I would still like to try to get analog support working for my DViCO FusionHDTV7 Dual Express. This seemed like my best prospect.
--
--Tim
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
