Hi Guys
What is the hardware revision of your CI board (printed on the bottom
of the PCB just above the PCI connector)?
I have a Rev 1.1 on my TT S2-3200 which requires polling, as well a
Rev 1.0 on an old NOVA-S card which provides an interrupt, both of
which work with the current driver. The version testing code was added
to the driver to handle these two boards. Maybe there is a new
revision out that the driver does not yet cater for.
A working CI and CAM combination should produce the following output
when the driver loads:
Linux video capture interface: v2.00
saa7146: register extension 'dvb'.
saa7146: register extension 'budget_ci dvb'.
ACPI: PCI Interrupt Link [LNKB] enabled at IRQ 5
PCI: setting IRQ 5 as level-triggered
ACPI: PCI Interrupt 0000:00:09.0[A] -> Link [LNKB] -> GSI 5 (level,
low) -> IRQ 5
saa7146: found saa7146 @ mem d8ae8000 (revision 1, irq 5) (0x13c2,0x1019).
saa7146 (0): dma buffer size 192512
DVB: registering new adapter (TT-Budget S2-3200 PCI)
adapter has MAC addr = 00:d0:5c:64:ba:14
input: Budget-CI dvb ir receiver saa7146 (0) as
/devices/pci0000:00/0000:00:09.0/input/input6
budget_ci: CI interface initialised
stb0899_get_dev_id: Device ID=[8], Release=[2]
stb0899_get_dev_id: Demodulator Core ID=[DMD1], Version=[1]
stb0899_get_dev_id: FEC Core ID=[FEC1], Version=[1]
stb0899_attach: Attaching STB0899
stb6100_attach: Attaching STB6100
dvb_ca adapter 0: DVB CAM detected and initialised successfully
DVB: registering frontend 0 (STB0899 Multistandard)...
> > 508 if ((ci_version & 0xa0) != 0xa0) {
> > 509 result = -ENODEV;
> > 510 goto error;
> > 511 }
> >
Martin, have you tried commenting out this test to see if you then can
get the 'CI interface initialised' message?
> Sorry I cannot offer any direct help. But I thought you might like to
> know you are not the only one fighting with this piece of hardware :-)
>
> Roger
Roger, in your other message you said your CI board reports the
version as 0xa0 which the driver expects to generate interrupts, which
clearly it doesn't. Have you tried changing the code so that the
driver uses polling for your CI version?
Werner
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
