Hi, since changeset 7469 the frontend driver of my technisat can't be loaded. Have someone a solution of this problem? test: hg clone http://linuxtv.org/hg/v4l-dvb hg update 7469 make && make install modprobe b2c2-flexcop-pci tail -f /log/messages ... Jun 7 22:43:15 [kernel] b2c2-flexcop: B2C2 FlexcopII/II(b)/III digital TV receiver chip loaded successfully Jun 7 22:43:15 [kernel] flexcop-pci: will use the HW PID filter. Jun 7 22:43:15 [kernel] flexcop-pci: card revision 2 Jun 7 22:43:15 [kernel] ACPI: PCI Interrupt 0000:01:08.0[A] -> Link [LNK2] -> GSI 5 (level, low) -> IRQ 5 Jun 7 22:43:15 [kernel] DVB: registering new adapter (FlexCop Digital TV device) Jun 7 22:43:15 [kernel] b2c2-flexcop: MAC address = 00:d0:d7:08:0d:7f Jun 7 22:43:15 [kernel] b2c2-flexcop: i2c master_xfer failed - Last output repeated 2 times - Jun 7 22:43:16 [kernel] mt352_read_register: readreg error (reg=127, ret==-121) Jun 7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed Jun 7 22:43:16 [kernel] nxt200x: nxt200x_readbytes: i2c read error (addr 0x0a, err == -121) Jun 7 22:43:16 [kernel] Unknown/Unsupported NXT chip: 00 00 00 00 00 Jun 7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed Jun 7 22:43:16 [kernel] lgdt330x: i2c_read_demod_bytes: addr 0x59 select 0x02 error (ret == -121) Jun 7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed - Last output repeated twice - Jun 7 22:43:16 [kernel] stv0297_readreg: readreg error (reg == 0x80, ret == -121) Jun 7 22:43:16 [kernel] b2c2-flexcop: i2c master_xfer failed Jun 7 22:43:16 [kernel] mt312_read: ret == -121 Jun 7 22:43:16 [kernel] b2c2-flexcop: no frontend driver found for this B2C2/FlexCop adapter ... bye, Nando _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
