Hi Hermann Thank you for your help with this. I have been away and today is the first chance I have had to re-visit it. It does look like we are getting somewhere.... After trying your suggestions, it seems that the tuner is located at 0x43 . Please see demesg below. The card is installed in a MythTV 8.04 Beta machine and I fired up the backend setup. The card is registered o.k. as DVB0 but when I do a channel scan, it cannot find any channels. Please let me know what else you would like me to try. Thanks & regards David [ 2072.184027] Linux video capture interface: v2.00 [ 2072.209134] saa7130/34: v4l2 driver version 0.2.14 loaded [ 2072.209171] saa7133[0]: found at 0000:01:07.0, rev: 240, irq: 22, latency: 32, mmio: 0xf3005000 [ 2072.209176] saa7133[0]: subsystem: 13c2:2804, board: Philips EUROPA V3 reference design [card=69,insmod option] [ 2072.209181] saa7133[0]: board init: gpio is c50000 [ 2072.269640] saa7133[0]: i2c eeprom 00: c2 13 04 28 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 [ 2072.269649] saa7133[0]: i2c eeprom 10: 00 00 00 00 ff 20 ff ff ff ff ff ff ff ff ff ff [ 2072.269655] saa7133[0]: i2c eeprom 20: 01 40 01 02 02 ff 03 01 08 ff 01 b7 ff ff ff ff [ 2072.269661] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 2072.269667] saa7133[0]: i2c eeprom 40: ff de 00 c6 86 10 ff ff ff ff ff ff ff ff ff ff [ 2072.269673] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 2072.269679] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 2072.269685] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 2072.273726] saa7133[0]: i2c scan: found device @ 0x10 [???] [ 2072.278730] saa7133[0]: i2c scan: found device @ 0x86 [tda9887] [ 2072.282365] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] [ 2072.286000] saa7133[0]: i2c scan: found device @ 0xa2 [???] [ 2072.289636] saa7133[0]: i2c scan: found device @ 0xa4 [???] [ 2072.293272] saa7133[0]: i2c scan: found device @ 0xa6 [???] [ 2072.296908] saa7133[0]: i2c scan: found device @ 0xa8 [???] [ 2072.300995] saa7133[0]: i2c scan: found device @ 0xaa [???] [ 2072.304179] saa7133[0]: i2c scan: found device @ 0xac [???] [ 2072.308267] saa7133[0]: i2c scan: found device @ 0xae [???] [ 2072.362357] tuner 2-0043: chip found @ 0x86 (saa7133[0]) [ 2072.362384] tda9887 2-0043: tda988[5/6/7] found @ 0x43 (tuner) [ 2072.362386] tuner 2-0043: type set to tda9887 [ 2072.366444] tuner 2-0063: chip found @ 0xc6 (saa7133[0]) [ 2072.367295] saa7133[0]: registered device video0 [v4l2] [ 2072.367311] saa7133[0]: registered device vbi0 [ 2072.424625] DVB: registering new adapter (saa7133[0]) [ 2072.424632] DVB: registering frontend 0 (Philips TDA10046H DVB-T)... [ 2072.449021] tda1004x: setting up plls for 48MHz sampling clock [ 2072.586103] tda1004x: found firmware revision 29 -- ok ----- Original Message ----- From: "hermann pitton" <hermann-pitton@xxxxxxxx> To: "David Porter" <dvb-t@xxxxxxxxxxxx> Cc: <linux-dvb@xxxxxxxxxxx> Sent: Sunday, April 13, 2008 6:16 AM Subject: Re: TechnoTrend T-3000 DVB-T PCI Hybrid Card > Hi David, > > Am Freitag, den 11.04.2008, 14:44 +1000 schrieb David Porter: >> Hi >> >> In the absence of any replies to my original request for help with this I >> did some more searching for any Linux information relating to this card. >> I found a post from 11 November 06 containing the tuner and decoder >> information which I have pasted in below. >> >> I'm hoping this may jog someone's memory as it seems odd that this card >> has >> been unsupported for so long. >> >> Thank you >> David Porter >> -------------------------------------- > > we need more information. > > A TechnoTrend re-branded saa7135chip was not seen so far. > >>From the eeprom it looks like the tuner is at 0x63. > > Please "modprobe -vr saa7134-dvb tuner" and then > "modprobe -v saa7134 card=69 i2c_scan=1" > > If it turns out that the tuner is at 0x63, card=69 has the tuner address > hardcoded at 0x61 in saa7134-cards.c and saa7134-dvb.c, a first step > could be to change that to 0x63. > > Also you seem to need tda10046 firmware. > > Cheers, > Hermann > > >> Re: Unsupported Video Card >> [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread >> Index] >> >> * Subject: Re: Unsupported Video Card >> * From: "Leonce Pflieger" >> * Date: Sat, 11 Nov 2006 15:52:38 +0100 >> * In-reply-to: >> <43a0ce660611110608q34d2184fhc3802f217692b3ad@xxxxxxxxxxxxxx> >> * References: >> <43a0ce660611110608q34d2184fhc3802f217692b3ad@xxxxxxxxxxxxxx> >> >> Hello, >> >> Same question for the following board. It is a Technotrend T-3000 >> DVB-T Hybrid. It seems there are a few cards that are still >> unrecognized even if the hardware embedded is well known and >> supported. :-\ >> Mine is : >> 01:01.0 Multimedia controller: Philips Semiconductors SAA7133 Video >> Broadcast Decoder (rev f0) >> Subsystem: Technotrend Systemtechnik GmbH Unknown device 2804 >> Flags: bus master, medium devsel, latency 64, IRQ 18 >> Memory at fa7ff000 (32-bit, non-prefetchable) [size=2K] >> Capabilities: [40] Power Management version 2 >> >> and the dmesg output shows : >> >> saa7130/34: v4l2 driver version 0.2.14 loaded >> ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 22 (level, low) -> IRQ 18 >> saa7133[0]: found at 0000:01:01.0, rev: 240, irq: 18, latency: 64, >> mmio: 0xfa7ff000 >> saa7133[0]: subsystem: 13c2:2804, board: UNKNOWN/GENERIC >> [card=0,autodetected] >> saa7133[0]: board init: gpio is c50000 >> saa7133[0]: i2c eeprom 00: c2 13 04 28 54 20 1c 00 43 43 a9 1c 55 d2 b2 >> 92 >> saa7133[0]: i2c eeprom 10: 00 00 00 00 ff 20 ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 20: 01 40 01 02 02 ff 03 01 08 ff 01 b7 ff ff ff >> ff >> saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 40: ff de 00 c6 86 10 ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: registered device video1 [v4l2] >> saa7133[0]: registered device vbi2 >> >> >> saa7134-dvb gives nothing, but if saa7134 was starded with card=69 and >> tuner=67 (tuner on the board is a TD1316A/SIHP / 3112 297 14251L# / >> 0448 SV20 000000) it returns : >> >> saa7130/34: v4l2 driver version 0.2.14 loaded >> ACPI: PCI Interrupt 0000:01:01.0[A] -> GSI 22 (level, low) -> IRQ 18 >> saa7133[0]: found at 0000:01:01.0, rev: 240, irq: 18, latency: 64, >> mmio: 0xfa7ff000 >> saa7133[0]: subsystem: 13c2:2804, board: Philips EUROPA V3 reference >> design [card=69,insmod option] >> saa7133[0]: board init: gpio is c50000 >> saa7133[0]: i2c eeprom 00: c2 13 04 28 54 20 1c 00 43 43 a9 1c 55 d2 b2 >> 92 >> saa7133[0]: i2c eeprom 10: 00 00 00 00 ff 20 ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 20: 01 40 01 02 02 ff 03 01 08 ff 01 b7 ff ff ff >> ff >> saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 40: ff de 00 c6 86 10 ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff >> ff >> tda9887 2-0043: chip found @ 0x86 (saa7133[0]) >> saa7133[0]: registered device video1 [v4l2] >> saa7133[0]: registered device vbi2 >> DVB: registering new adapter (saa7133[0]). >> DVB: registering frontend 1 (Philips TDA10046H DVB-T)... >> >> which seems quite good, but is followed by... >> >> tda1004x: setting up plls for 48MHz sampling clock >> tda1004x: timeout waiting for DSP ready >> tda1004x: found firmware revision 0 -- invalid >> tda1004x: booting from eeprom >> tda1004x: timeout waiting for DSP ready >> tda1004x: found firmware revision 0 -- invalid >> tda1004x: firmware upload failed >> >> :-( >> Could someone help ? Am I the only guy on earth trying to make a T3000 >> work on Linux ?? >> >> Thanks for your attention ! >> >> >> ----- Original Message ----- >> From: "David Porter" <dvb-t@xxxxxxxxxxxx> >> To: <linux-dvb@xxxxxxxxxxx> >> Sent: Monday, April 07, 2008 12:47 PM >> Subject: TechnoTrend T-3000 DVB-T PCI Hybrid Card >> >> >> > Hi >> > >> > I have searched the wiki, forums and threads and cannot find any >> > information >> > about getting this card to work in Linux. >> > Does anyone have any experience with it? >> > It is one of their "budget" range that has no hardware mpeg decoder. >> > >> > I'm only interested in getting DVB-T working, not analogue. >> > >> > There is a good picture of it here:- >> > http://www.dvbmagic.de/tv-karten/technotrend-budget-t-3000.htm >> > >> > Thanks >> > David Porter >> > >> > > > _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
