On Dienstag, 18. März 2008, Mauro Carvalho Chehab wrote: > On Sun, 16 Mar 2008 11:31:37 +0100 > > For this to work, you'll need to set xc3028 parameters. This device needs a > reset during firmware load. This is done via xc3028_callback. To reset, you > need to turn some GPIO values, and then, return they back to their original > values. The GPIO's are device dependent. So, you'll need to check with some > software like Dscaler's regspy.exe what pins are changed during reset. I can only have a look at the wiring. > > Also, there are two ways for audio to work with xc3028/2028: MTS mode and > non-mts. You'll need to test both ways. > > A final notice: most current devices work fine with firmware v2.7. However, > a few devices only work if you use an older firmware version. > > Could you please send us the logs with i2c_scan=1? > I do not have that hardware. I only have the A700 without XC2028 soldered on it. But maybe Peter can help out on this. > Please, use the latest version of v4l-dvb, since I did some fixes for cx88 > and saa7134 there recently. > I do use latest v4l-dvb tree and create patches on top of this. As this card is labled Hybrid+FM I should also add a radio section, I guess. Regards Matthias -- Matthias Schwarzott (zzam) _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
