I am unable to tune digital TV on a Tevion DVB T-220RF using kernel 2.6.24.3 > sudo scan -v /usr/share/doc/dvb-utils/examples/scan/dvb-t/au-Melbourne scanning /usr/share/doc/dvb-utils/examples/scan/dvb-t/au-Melbourne using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 226500000 1 3 9 3 1 1 0 initial transponder 177500000 1 2 9 3 1 2 0 initial transponder 191625000 1 3 9 3 1 1 0 initial transponder 219500000 1 3 9 3 1 1 0 initial transponder 536625000 1 2 9 3 1 2 0 >>> tune to: 226500000:INVERSION_AUTO:BANDWIDTH_7_MHZ:FEC_3_4:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_16:HIERARCHY_NONE >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 >>> tuning status == 0x00 WARNING: >>> tuning failed!!! This problem seems identical to that solved in http://www.linuxtv.org/pipermail/linux-dvb/2006-January/007689.html however the relevant code seems to have changed since the fix was described and I can't seem to replicate it using the new driver code. Specifically, manually editing saa7134-cards.c or tda8290.c to set the the tuner address to 0x60 from 0x61 just stops the tda8290 driver from loading. I am using kernel 2.6.24.3, The relevant dmesg entries are: [ 46.632313] saa7133[0]: found at 0000:00:0a.0, rev: 208, irq: 20, latency: 32, mmio: 0xe6008000 [ 46.632946] saa7133[0]: subsystem: 17de:7201, board: Tevion/KWorld DVB-T 220RF [card=88,autodetected] [ 46.633026] saa7133[0]: board init: gpio is 100 [ 46.770494] saa7133[0]: i2c eeprom 00: de 17 01 72 ff ff ff ff ff ff ff ff ff ff ff ff [ 46.771227] saa7133[0]: i2c eeprom 10: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.771956] saa7133[0]: i2c eeprom 20: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.772693] saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.773440] saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.774167] saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.774894] saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 46.775623] saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff [ 47.009197] tuner 0-004b: chip found @ 0x96 (saa7133[0]) [ 47.057166] tda8290 0-004b: setting tuner address to 61 [ 47.161150] tuner 0-004b: type set to tda8290+75a [ 47.209142] tda8290 0-004b: setting tuner address to 61 [ 47.313131] tuner 0-004b: type set to tda8290+75a [ 47.315906] saa7133[0]: registered device video0 [v4l2] [ 47.315984] saa7133[0]: registered device vbi0 [ 47.316060] saa7133[0]: registered device radio0 ...... [ 47.611627] DVB: registering new adapter (saa7133[0]) [ 47.611690] DVB: registering frontend 0 (Philips TDA10046H DVB-T)... [ 47.681091] tda1004x: setting up plls for 48MHz sampling clock ....... [ 49.614319] tda1004x: found firmware revision 23 -- ok (The driver doesn't seem to pay any attention to firmware in /lib/firmware) FWIW as an analogue tuner the saa7134 works 100% Thanks for any help, Ian Haywood _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
