Hi, Hermann hermann pitton schrieb: > Hi, Harmut, > > was able to purchase such a device recently. > > For me it looks like they have been on OEM stuff only previously. > The panel for the internal connectors is soldered, the analog audio out > is there too and fine. > > For all what I could look up, it had never support for the PC-39 remote > we added for revision 2.0, since all seen so far comes up with gpio init > 0, the remote IRQ to sample from is never active. > > Folks, please report if it comes with that RC5 style remote too. > > It has a firmware eeprom. > > It turns out, and some previous reports pointed to it without to become > speficic, but contradictions on what the ms driver does on antenna input > switching, that this one has only a male FM connector and a female RF > connector. > > So, currently we force people with that card to put the DVB-T antenna > input on the male FM-connector, which might be quit inconvenient ... > indeed ;-) > If nobody disagrees, and also my thesis of the not ever delivered remote > is right, we should change the auto detection to use card=81, the > Philips Tiger reference design you developed on. > > Cheers, > Hermann > > > Stuff currently in that machine. We have also one byte different in the > eeprom here. > > Linux video capture interface: v2.00 > saa7130/34: v4l2 driver version 0.2.14 loaded > saa7133[0]: found at 0000:01:07.0, rev: 208, irq: 17, latency: 32, mmio: 0xe8000000 > saa7133[0]: subsystem: 1043:4857, board: Philips Tiger reference design [card=81,insmod option] > saa7133[0]: board init: gpio is 0 > saa7133[0]: i2c eeprom 00: 43 10 57 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7133[0]: i2c eeprom 10: 00 01 20 00 ff 20 ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 cb ff ff ff ff > ^^ <snip> > tuner' 2-004b: chip found @ 0x96 (saa7133[0]) > tda829x 2-004b: setting tuner address to 61 > tda829x 2-004b: type set to tda8290+75a > saa7133[0]: registered device video0 [v4l2] > saa7133[0]: registered device vbi0 > saa7133[0]: registered device radio0 > saa7133[1]: found at 0000:01:08.0, rev: 208, irq: 19, latency: 32, mmio: 0xe8001000 > saa7133[1]: subsystem: 1043:4862, board: ASUSTeK P7131 Dual [card=78,autodetected] > saa7133[1]: board init: gpio is 0 <------ remote sensor is broken, else 0x40000 > input: saa7134 IR (ASUSTeK P7131 Dual) as /class/input/input6 > tuner' 3-004b: chip found @ 0x96 (saa7133[1]) > tda829x 3-004b: setting tuner address to 61 > tda829x 3-004b: type set to tda8290+75a > saa7133[1]: i2c eeprom 00: 43 10 62 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7133[1]: i2c eeprom 10: 00 01 20 00 ff 20 ff ff ff ff ff ff ff ff ff ff > saa7133[1]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 d6 ff ff ff ff > ^^ <snip> I guess you checked the entire eepron content ;-) According to the documentation i have, there is no config byte describing the assignment of antenna sockets. The document says that this byte is a checksum!!! I will try to get some information. I found one discrepancy: The Tiger uses LINE1 for the audio baseband inputs while the ASUS uses LINE2. Can you cross check this? Best regards Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
