On Wed, Feb 27, 2008 at 11:34:58AM -0500, Steven Toth wrote: > Andy Wettstein wrote: >> Hi, >> >> I just installed a hauppauge hvr1250 and it seems to be ok, but >> there are ton of messages being logged. I am wondering if these >> messages are something to be concerned about. >> >> uname: >> Linux beerme 2.6.24-1-686 #1 SMP Mon Feb 11 14:37:45 UTC 2008 i686 GNU/Linux >> >> >> Relevant dmesg output: >> >> cx23885 driver version 0.0.1 loaded >> ACPI: PCI Interrupt Link [APC5] enabled at IRQ 16 >> ACPI: PCI Interrupt 0000:01:00.0[A] -> Link [APC5] -> GSI 16 (level, low) -> IRQ 19 >> CORE cx23885[0]: subsystem: 0070:7911, board: Hauppauge WinTV-HVR1250 [card=3,autodetected] >> cx23885[0]: i2c bus 0 registered >> cx23885[0]: i2c bus 1 registered >> cx23885[0]: i2c bus 2 registered >> tveeprom 0-0050: Encountered bad packet header [ff]. Corrupt or not a Hauppauge eeprom. >> cx23885[0]: warning: unknown hauppauge model #0 >> cx23885[0]: hauppauge eeprom: model=0 >> cx23885[0]: cx23885 based dvb card >> MT2131: successfully identified at address 0x61 >> DVB: registering new adapter (cx23885[0]) >> DVB: registering frontend 0 (Samsung S5H1409 QAM/8VSB Frontend)... >> cx23885[0]/0: found at 0000:01:00.0, rev: 2, irq: 19, latency: 0, mmio: 0xfd800000 >> PCI: Setting latency timer of device 0000:01:00.0 to 64 > > The driver was loaded with debug enabled. Thanks. Much quieter with the debugging off. Now to figure out why mythbackend segfaults recording from this card. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
