On Jan 17, 2008, at 8:21 PM, Manu Abraham wrote: > Tuomas Jousimaa wrote: >> On Jan 17, 2008, at 7:45 PM, Manu Abraham wrote: >>> Tuomas Jousimaa wrote: >>>> Hi >>>> I just bought the new Terratec Cinergy C PCI -card. It would >>>> seem that it isn't supported yet by any drivers. With Manus >>>> mantis-drivers recognize the card, but the frontend doesn't work. >>> > > Please try the attached patch whether it helps. Apply it on to the > mantis tree > The frontend used is the tda10021. > > In case of any trouble, plese send the log messages too. I'm afraid the patch isn't working yet for me. Now it seems to recognize the frontend, but I can't get any signal out of it. I'm not quite sure which logs you meant to attach, but here are some for starters. If anything else is needed, please ask. -Tuomas dmesg output during boot: [ 32.533271] found a VP-2033 PCI DVB-C device on (05:06.0), [ 32.533273] Mantis Rev 1 [153b:1178], irq: 19, latency: 32 [ 32.533276] memory: 0xc6000000, mmio: 0xf89ea000 [ 32.535964] MAC Address=[00:08:ca:1c:71:d1] [ 32.535990] mantis_alloc_buffers (0): DMA=0x37f40000 cpu=0xf7f40000 size=65536 [ 32.535996] mantis_alloc_buffers (0): RISC=0x37e90000 cpu=0xf7e90000 size=1000 [ 32.535998] DVB: registering new adapter (Mantis dvb adapter) --- [ 33.202130] mantis_frontend_init (0): Probing for CU1216 (DVB-C) [ 33.203526] TDA10021: i2c-addr = 0x0c, id = 0x7d [ 33.203529] mantis_frontend_init (0): found Philips CU1216 DVB-C frontend @ 0x0c [ 33.203531] mantis_frontend_init (0): Mantis DVB-C Philips CU1216 frontend attach success [ 33.203536] DVB: registering frontend 0 (Philips TDA10021 DVB-C)... [ 33.203721] ACPI: PCI Interrupt 0000:05:07.0[A] -> Link [APC2] -> GSI 17 (level, low) -> IRQ 20 [ 33.203742] saa7146: found saa7146 @ mem f8c7a000 (revision 1, irq 20) (0x153b,0x1156). [ 33.203748] saa7146 (0): dma buffer size 192512 [ 33.203750] DVB: registering new adapter (Terratec Cinergy 1200 DVB-C) [ 33.246552] adapter failed MAC signature check [ 33.246555] encoded MAC from EEPROM was ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff dmesg output when attempting to tune into a channel with czap: [ 1810.802565] mantis start feed & dma [ 1815.706411] mantis stop feed and dma czap output: root@htpc:~# czap -c channels.conf "TV1" using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' 1 TV1:274000000:INVERSION_AUTO:6900000:FEC_NONE:QAM_128:512:650:17 1 TV1: f 274000000, s 6900000, i 2, fec 0, qam 4, v 0x200, a 0x28a status 00 | signal 0000 | snr ffff | ber 00000000 | unc 00000000 | status 00 | signal 0000 | snr ffff | ber 00000000 | unc 00000000 | status 00 | signal 0000 | snr ffff | ber 00000000 | unc 00000000 | _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
