Chaogui Zhang wrote: > On Sun, Jan 13, 2008 at 01:48:14PM -0500, Steven Toth wrote: >> Chaogui Zhang wrote: >>> On Jan 13, 2008 11:29 AM, Steven Toth <stoth@xxxxxxxxxxx> wrote: >>>>> TS is working, see the latest patches in my xc5000-analog tree. >>>>> >>>>> I'll look at these dumps now. >>>>> >>>> Zhang, these register values didn't help, which means that we're >>>> probably missing minor configuration parameters on the s5h1409 demod >>>> when running in parallel mode. >>>> >>>> That being said I switch the pinnacle 800i configuration in cx88 to >>>> switch to use serial mode, also patch a couple of registers, now it's >>>> streaming digital transport (QAM was tested) correctly. ATSC should also >>>> work just as well. >>> Hi, Steve, >>> >>> I am on the road right now, so I could only do some limited testing with >>> command line tools. >>> >>> With the latest change set 6957, seems like the TS at least now have >>> data output, but I am not sure if it is correct, since the PIDs (reported >>> by scan) are not right (compared to the PIDs reported on a working card >>> at the same frequency). In fact, the PIDs seem like just random numbers. >>> >>> Or do you have a more recent patch? >> No. >> >> When the stream starts, for the first second or so the demod delivers >> junk, this is normal across many different 1409 based designs. After >> that dvbtraffic is reporting consistent bitrates and pids on the machine >> I'm testing on. >> >> It's looking good for me, 38Mbps spread correctly over 3 video pids, >> padding on 1fff and low volume PSIP information on 0, 1 as well as >> 200kbps audio channels. >> >> Channels are encrypted, but the rates look perfect. > > I did more testing on the 800i. Unfortunately, it is not working for me. > When I have azap running on a known working frequency (local nbc > station) and use scan -c, it reports garbage pids even after I have the > azap running for like two minutes. Trying to play the stream with > mplayer gives a message that says "libavformat file detected" but no > video/audio shows up. If I use option -demuxer mpegts, mplayer exits > immediately saying EOF. Run dvbtraffic, what does it show? - Steve _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
