LS,
as I'm new to this list, and I've googled around trying to solve
this problem, I do not know if this has been addressed already or not.
Recently I've bought a KNC1 DVB-C card to use in my new Fedora 8 pvr.
But the kernel does not recognize this card, and thus doesn't know
which driver to load. Running lspci, it shows these results:
$ sudo /sbin/lspci -s 00:08.0 -vvv
00:08.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
Subsystem: Unknown device 1800:0023
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort-
<TAbort- <MAbort- >SERR- <PERR-
Latency: 32 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 5
Region 0: Memory at fe203000 (32-bit, non-prefetchable) [size=512]
It has an SAA7146 (is recognized), but it has an NXP tin box (CU1216L/A I G
H-3 SV20 0712) on it which is doesn't know. If needed I can post a picture
of it here. Or an a website. Is this a known problem?
Many thanks, cu l8r, Edgar.
--
\|||/
(o o) Just curious...
----ooO-(_)-Ooo---------------------------------------------------------
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
