file).
lsusb -v
---
idVendor 0x2304 Pinnacle Systems, Inc. [hex]
idProduct 0x0236
bcdDevice 1.00
iManufacturer 1 LITEON
iProduct 2 Pinnacle 72e
iSerial 3 63N
----
I use the latest development version of Patrick Boettcher's repository.
By adding the USB-ID to the correspondig section in dib0700_devices.c (DiBComs
Reference design, Pinnacle PCTV with Flash) , I was able to download the
firmware, but the frontend does not come up.
dmesg: with debug
----
dvb-usb: found a 'Pinnacle PCTV DVB-T Solo/Standard/Ultimate (72e)' in cold state,
will try to load a firmware
dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.10.fw'
dib0700: firmware started successfully.
dvb-usb: found a 'Pinnacle PCTV DVB-T Solo/Standard/Ultimate (72e)' in warm
state.
dvb-usb: will pass the complete MPEG2 transport stream to the software
demuxer.
DVB: registering new adapter Pinnacle PCTV DVB-T Solo/Standard/Ultimate
(72e)
ep 0 read error (status = -32)
I2C read failed on address 40
ep 0 read error (status = -32)
I2C read failed on address 9
ep 0 read error (status = -32)
I2C read failed on address 40
dvb-usb: no frontend was attached by 'Pinnacle PCTV DVB-T
Solo/Standard/Ultimate (72e)'
dvb-usb: Pinnacle PCTV DVB-T Solo/Standard/Ultimate (72e) successfully initialized
and connected.
----
Any ideas ?`
Keep up the good work,
Rene
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
