The Pinnacle PCTV 72e is apparrently based on the DiBCom STK7070P ( see .inf file). lsusb -v --- idVendor 0x2304 Pinnacle Systems, Inc. [hex] idProduct 0x0236 bcdDevice 1.00 iManufacturer 1 LITEON iProduct 2 Pinnacle 72e iSerial 3 63N ---- I use the latest development version of Patrick Boettcher's repository. By adding the USB-ID to the correspondig section in dib0700_devices.c (DiBComs Reference design, Pinnacle PCTV with Flash) , I was able to download the firmware, but the frontend does not come up. dmesg: with debug ---- dvb-usb: found a 'Pinnacle PCTV DVB-T Solo/Standard/Ultimate' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.10.fw' dib0700: firmware started successfully. dvb-usb: found a 'Pinnacle PCTV DVB-T Solo/Standard/Ultimate (72e)' in warm state. dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. DVB: registering new adapter (Pinnacle PCTV DVB-T Solo/Standard/Ultimate) (72e) ep 0 read error (status = -32) I2C read failed on address 40 ep 0 read error (status = -32) I2C read failed on address 9 ep 0 read error (status = -32) I2C read failed on address 40 dvb-usb: no frontend was attached by 'Pinnacle PCTV DVB-T Solo/Standard/Ultimate (72e)' dvb-usb: Pinnacle PCTV DVB-T Solo/Standard/Ultimate successfully initialized and connected. ---- Any ideas ?` Keep up the good work, Rene _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
