|
I have a DVICO NANO but I am having the same
troubles others had in June. It appears it is not being recognised as being
cold.
I have followed the instructions at http://fremnet.net/article/228/dvico-fusionhdtv-dual-digital-4-under-linux and
all went well except the frontend not set. dmesg follows
usb 5-8: new high speed USB device using ehci_hcd
and address 9
usb 5-8: configuration #1 chosen from 1 choice dvb-usb: found a 'DViCO FusionHDTV DVB-T NANO2' in warm state. dvb-usb: bulk message failed: -22 (2/0) dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. DVB: registering new adapter (DViCO FusionHDTV DVB-T NANO2) dvb-usb: bulk message failed: -110 (1/0) dvb-usb: bulk message failed: -110 (3/0) dvb-usb: bulk message failed: -110 (3/0) dvb-usb: bulk message failed: -110 (5/0) dvb-usb: no frontend was attached by 'DViCO FusionHDTV DVB-T NANO2' dvb-usb: DViCO FusionHDTV DVB-T NANO2 successfully initialized and connected. Is there any other information that may help I am
running vanilla 2.6.23.1 kernel on Scientific linux 5.0
Thanks a lot for the work so far.
Stephen Collier
|
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
