Michael Krufky wrote: > cromworshipper-linuxdvb@xxxxxxxxx wrote: >> I just picked up this card and I'm looking forward to trying it. I run Fedora 7 x86_64 2.6.23-1.10. I guess I'll try the steps as described at http://linuxtv.org/wiki/index.php/How_to_install_DVB_device_drivers and see how it goes. >> >> How close are we to getting NTSC to work? Do I need firmware for this card? >> >> Advice and pointers welcome. > > Funny that you should ask about analog mode NTSC just a week or two after we've confirmed that QAM works. (ATSC has always worked, QAM needed a small patch to fix). > > The NTSC tuner is already supported, but the cx23885 bridge driver does not yet support analog mode. > > I don't know how long that will take, but it shouldn't be too far off. > > You don't need any firmware for the hvr1800. > > Regards, > > Mike The cx23885 has a modified version of the cx25840 a/v decoder inside it. It uses different firmware than the normal cx25840 driver already present in Linux. As such, to support analog, I also have to push some patches into that driver for the differing registers (and firmware). Analog preview and analog encoder running well in lab conditions and they are pretty stable, but I need to spend quality time cherry picking pieces from multiple development trees to build something acceptable to the linuxtv community. Soon, think weeks not days. - Steve _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
