Dear all,
I am having problems with a full featured TT-1200 dvb-t (sometimes also
called technotrend dvb-t premium) card.
It does not find the frontend and if I manually fiddle with the code (I
simply had to remove the break in line 2176 of av7110.c in hg to allow
fallthrough) to make it load the Spase SP8870 DVB-T it successfully
registers this frontend and loads the sp8870 firmware but then it still
refuses to tune to any channel...
As the card is listed as supported I am a bit confused what is going on
- any ideas?
Soeren
Details follow:
kernel is 2.6.23.1
#lspci
00:0b.0 0480: 1131:7146 (rev 01)
Subsystem: 13c2:0000
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66MHz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 20
Region 0: Memory at d3800000 (32-bit, non-prefetchable) [size=512]
# dmesg
dvb-ttpci: info @ card 2: firm f0240009, rtsl b0250018, vid 71010068, app 80f12623
dvb-ttpci: firmware @ card 2 supports CI link layer interface
dvb-ttpci: Crystal audio DAC @ card 2 detected
saa7146_vv: saa7146 (2): registered device video1 [v4l2]
saa7146_vv: saa7146 (2): registered device vbi1 [v4l2]
ves1820: ves1820_readreg(): readreg error (reg == 0x1a,ret == -121)
DVB: registering frontend 2 (Spase SP8870 DVB-T)...
input: DVB on-card IR receiver as /devices/pci0000:00/0000:00:0b.0/input/input9
dvb-ttpci: found av7110-1.
hires photo taken of the card or further info on request...
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
