Hi Michael, Am Dienstag, den 11.09.2007, 07:59 -0700 schrieb Mr misha volk: > i have a very similar problem as the previous poster > however neither card=87 or 88 worked for me. Any > clues? > > The Typhoon DVB-T Duo Digital/Analog PCMCIA card > lspci > is: > > 0000:06:00.0 Multimedia controller: Philips > Semiconductors SAA7133 Video Broadcast Decoder (rev > f0) > Subsystem: Unknown device 4e42:0502 > Flags: bus master, medium devsel, latency 64, > IRQ 11 > Memory at 26000000 (32-bit, non-prefetchable) > [size=2K] > Capabilities: [40] Power Management version 2 > > > > If I insert the card, everything is fine for normal > analog TV. Dmesg tells me: > ########## > [17185944.644000] pccard: CardBus card inserted into > slot 1 > [17185944.644000] PCI: Enabling device 0000:06:00.0 > (0000 -> 0002) > [17185944.644000] ACPI: PCI Interrupt 0000:06:00.0[A] > -> Link [C187] -> GSI 11 (level, low) -> IRQ 11 > [17185944.644000] saa7133[0]: quirk: PCIPCI_NATOMA > [17185944.644000] saa7133[0]: found at 0000:06:00.0, > rev: 240, irq: 11, latency: 0, mmio: 0x26000000 > [17185944.644000] PCI: Setting latency timer of device > 0000:06:00.0 to 64 > [17185944.644000] saa7133[0]: subsystem: 4e42:0502, > board: Typhoon DVB-T Duo Digital/Analog Cardbus > [card=60,autodetected] > [17185944.644000] saa7133[0]: board init: gpio is > e010000 > [17185944.820000] tuner 1-004b: chip found @ 0x96 > (saa7133[0]) > [17185944.868000] tuner 1-004b: setting tuner address > to 61 > [17185944.908000] tuner 1-004b: tuner: type set to > tda8290+75a > [17185945.004000] saa7133[0]: i2c eeprom 00: 42 4e 02 > 05 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > [17185945.004000] saa7133[0]: i2c eeprom 10: 00 ff 22 > 0f ff 20 ff ff ff ff ff ff ff ff ff ff > [17185945.004000] saa7133[0]: i2c eeprom 20: 01 40 01 > 03 03 01 01 03 08 ff 01 81 ff ff ff ff > [17185945.004000] saa7133[0]: i2c eeprom 30: ff ff ff > ff ff ff ff ff ff ff ff ff ff ff ff ff > [17185945.004000] saa7133[0]: i2c eeprom 40: ff 25 00 > c0 ff 10 07 01 c2 96 00 16 22 15 ff ff > [17185945.004000] saa7133[0]: i2c eeprom 50: ff ff ff > ff ff ff ff ff ff ff ff ff ff ff ff ff > [17185945.004000] saa7133[0]: i2c eeprom 60: ff ff ff > ff ff ff ff ff ff ff ff ff ff ff ff ff > [17185945.004000] saa7133[0]: i2c eeprom 70: ff ff ff > ff ff ff ff ff ff ff ff ff ff ff ff ff > [17185947.508000] saa7133[0]: registered device video0 > [v4l2] > [17185947.508000] saa7133[0]: registered device vbi0 > [17185947.508000] saa7133[0]: registered device radio0 > [17185947.516000] DVB: registering new adapter > (saa7133[0]). > [17185947.516000] DVB: registering frontend 0 (Philips > TDA10046H DVB-T)... > [17185947.516000] saa7133[0]/alsa: saa7133[0] at > 0x26000000 irq 11 registered as card -1 > > > running kaffeine i get with dmesg: > [17186086.808000] tda1004x: found firmware revision ff > -- invalid > [17186086.976000] tda1004x: booting from eeprom > [17186087.520000] tda1004x: found firmware revision 23 > -- ok > [17186087.948000] tda1004x: pll set failed > [17186120.220000] tda1004x: pll set failed > > When i run the following: > sudo modprobe -r saa7134_alsa saa7134; sudo modprobe > saa7134 card=88 > > I still get card=60. > > [17188174.544000] saa7133[0]: subsystem: 4e42:0502, > board: Typhoon DVB-T Duo Digital/Analog Cardbus > [card=60,autodetected] > > uname -a: > Linux ubuntu 2.6.15-28-386 #1 PREEMPT Thu May 10 > 09:45:43 UTC 2007 i686 GNU/Linux The 2.6.15 has only initial support for DVB-T first time on tda8275a for the Philips Tiger reference design and the Asus P7134 Dual in the variant I used that time. (1043:4862) As Hartmut said, we had a serious problem here, since the manufacturer of your card changed the tuners, but not the PCI subsystem on the eeprom. The old DVB tuning code for the tda827x can make that second tda827xa tuner on your card unusable, needs a cold reboot or unload all saa7134 stuff and _then_ eject the card. It does not disable power before that currently and Markus has seen crashes I think. TV analog is already fine with the new tuner type and auto detects it. That makes card=60 still working for analog, but not yet for DVB-T, since wrong tuner. On later kernels with support for card=88, Jan used that as workaround for DVB-T and default card=60 for analog. Try current v4l-dvb mercurial master. This has now autodetection code for the different tuner types in the tda827x frontend too and should work with card=60 also for DVB-T with the tuner at address 0x60. With 2.6.15 you come nowhere. Cheers, Hermann _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
