On 9/6/07, P. van Gaans <w3ird_n3rd@xxxxxxx> wrote: > On 09/06/2007 04:21 PM, Guillaume Marçais wrote: > > On 9/3/07, P. van Gaans <w3ird_n3rd@xxxxxxx> wrote: > >> On 09/03/2007 04:57 PM, P. van Gaans wrote: > >>> On 09/03/2007 03:58 PM, Guillaume Marçais wrote: > >>>> I have a PowerCAM.Pro CAM module, attached to a TechnoTrend budget > >>>> S1500, and it does not seem to work with linuxtv. When it is plugged > >>>> in, I do not get anything, even scan returns only timeouts. If the > >>>> common interface is unplugged, then scan returns over 1400 channels. > >>>> So there seem to be some sort of an incompatibility. > >>>> > >>>> The CAM module that I should have come with the pack I bought is an > >>>> AstonCrypt Dual. Does this CAM module work with linuxtv? > >>>> > >>>> Guillaume. > >>>> > >>>> OS: XUbuntu Feisty Fawn > >>>> Provider: CanalSat > >>>> > >>>> _______________________________________________ > >>>> linux-dvb mailing list > >>>> linux-dvb@xxxxxxxxxxx > >>>> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > >>>> > >>> Check out http://linuxtv.org/wiki/index.php/TechnoTrend_TT-budget_S-1500 > >>> and please update the article with new CAMs as it seems you have at > >>> least one. But make sure your card works properly, does it work with the > >>> Aston? > >>> > >>> _______________________________________________ > >>> linux-dvb mailing list > >>> linux-dvb@xxxxxxxxxxx > >>> http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > >>> > >> Stupid me, forgot to ask.. What does dmesg say when you insert/eject > >> your CAM and while it's in it? > > > > OK, sorry for the noise. Finally, the PowerCAM.Pro works fine. I guess > > it was not plugged in properly or something. After taking it out and > > putting it back in, it works, with no software modification. I can see > > encrypted channels fine with kaffeine. Now if I could get MythTV to > > work... But that's another story for another mailing list :) > > > > I can update the wiki page > > http://linuxtv.org/wiki/index.php/TechnoTrend_TT-budget_S-1500. My > > concern is I do not know what version of the CI is in the machine and > > I do not have physical access to it. Can I tell from the logs/dmesg? > > > > Guillaume. > > > > _______________________________________________ > > linux-dvb mailing list > > linux-dvb@xxxxxxxxxxx > > http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb > > > > Probably not (at least I wouldn't know how). You could add a note about > the powerCAM or make a new table for unknown CI versions. > > Btw, I personally haven't seen any difference in CAM compatibility > between 1.0 and 1.1, I doubt there is any. > Done. Guillaume. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
