On Mon, 2007-08-06 at 00:21 +0200, hermann pitton wrote: > Hi Paolo, > > Am Sonntag, den 05.08.2007, 09:56 +0200 schrieb Paolo Dell'Aquila: > > Hallo, I'm writing here becuase I need some informations about the > > Asus P7131 Hybrid (1043:4876, board: ASUSTeK P7131 Hybrid > > [card=112,autodetected]). > > > > 1. > > Which is the newest firmware for this board? I downloaded the > > "revision 29" from lifeview, is this the right one? > > latest available for download, as far as I know. how does one find out which firmware revision one is using? I am asking as I have severe stability issues (the card works for a couple of hours then at some point cold freezes the system). Note that with the other budget card this setup works fine (uptime months...). > > 3. > > Digital reception is not very good. If I use my Pinnacle Hybryd Pro > > Stick I can watch more channels and reception is more stable. There is > > something I can do? I read about a "lowNoiseAmplifier" in kernel 2.6.22. > > I have kernel 2.6.20. Do I have to upgrade? > > (Sorry, but I cannot re-test the board under windows so I don't know if > > it's a "driver" problem or a "feature" of the board, lol) > > No need to upgrade, since you have already updated to recent v4l-dvb > code. You might try the attached patch, which sets the other atenna > input during digital usage and check if DVB-T reception > is /unchanged/better/worse. It could very well be a bad reception -> firmware crash -> card amok problem... anyway I intended to use this card in dvb-t only mode and I am on 2.6.22.1 and used the options saa7134 card=112 tuner=54 gpio_tracking=1 i2c_scan=1 as suggested in the wiki... does this card work reliably for you (stable in a 24/7 vdr setup?) dmesg follows ... saa7130/34: v4l2 driver version 0.2.14 loaded saa7133[0]: found at 0000:00:0f.0, rev: 209, irq: 7, latency: 16, mmio: 0xd9000000 saa7133[0]: subsystem: 1043:4876, board: ASUSTeK P7131 Hybrid [card=112,insmod option] saa7133[0]: board init: gpio is 0 saa7133[0]: gpio: mode=0x0000000 in=0x0000000 out=0x0000000 [pre-init] input: saa7134 IR (ASUSTeK P7131 Hybri as /class/input/input13 saa7133[0]: i2c eeprom 00: 43 10 76 48 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 saa7133[0]: i2c eeprom 10: ff ff ff 0f ff 20 ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: 01 40 01 02 03 01 01 03 08 ff 00 d5 ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 03 32 55 50 ff ff ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c scan: found device @ 0x10 [???] saa7133[0]: i2c scan: found device @ 0x96 [???] saa7133[0]: i2c scan: found device @ 0xa0 [eeprom] saa7133[0]: gpio: mode=0x0200000 in=0x0000000 out=0x0000000 [Television] saa7133[0]: gpio: mode=0x0200000 in=0x0000000 out=0x0000000 [Television] tuner 7-004b: chip found @ 0x96 (saa7133[0]) tuner 7-004b: setting tuner address to 61 tuner 7-004b: type set to tda8290+75a tuner 7-004b: setting tuner address to 61 tuner 7-004b: type set to tda8290+75a saa7133[0]: registered device video1 [v4l2] saa7133[0]: registered device vbi1 saa7133[0]: registered device radio0 saa7133[0]: gpio: mode=0x0200000 in=0x0000000 out=0x0000000 [Television] DVB: registering new adapter (saa7133[0]) DVB: registering frontend 2 (Philips TDA10046H DVB-T)... tda1004x: setting up plls for 48MHz sampling clock tda1004x: found firmware revision 20 -- ok Best, Soeren _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
