|
After running with the new firmware and current hg drivers for about 18 hours, I've got a USB disconnect. Below are excerpts from my log; Aug 1 18:14:13 htpc2 kernel: MT2060: Spurs after : f_lo1: 1811000 f_lo2: 1196700 (kHz) Aug 1 18:14:13 htpc2 kernel: MT2060: IF1: 1229MHz Aug 1 18:14:13 htpc2 kernel: MT2060: PLL freq=578166kHz f_lo1=1811000kHz f_lo2=1196700kHz Aug 1 18:14:13 htpc2 kernel: MT2060: PLL div1=113 num1=12 div2=74 num2=6502 Aug 1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 43 71 6 96 95 Aug 1 18:14:13 htpc2 kernel: MT2060: IF1: 1204MHz Aug 1 18:14:13 htpc2 kernel: MT2060: PLL freq=482000kHz f_lo1=1686000kHz f_lo2=1167850kHz Aug 1 18:14:13 htpc2 kernel: MT2060: PLL div1=105 num1=24 div2=72 num2=8115 Aug 1 18:14:13 htpc2 kernel: MT2060: PLL [1..5]: 56 69 3 fb 91 Aug 1 18:14:14 htpc2 kernel: MT2060: IF1: 1229MHz Aug 1 18:14:14 htpc2 kernel: MT2060: PLL freq=506000kHz f_lo1=1735000kHz f_lo2=1192850kHz Aug 1 18:14:14 htpc2 kernel: MT2060: PLL div1=108 num1=28 div2=74 num2=4531 Aug 1 18:14:14 htpc2 kernel: MT2060: PLL [1..5]: 57 6c 3 1b 95 Aug 1 18:14:14 htpc2 kernel: modifying (0) streaming state for 0 Aug 1 18:14:14 htpc2 kernel: data for streaming: 0 10 Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1 Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12 Aug 1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1 Aug 1 18:14:15 htpc2 kernel: data for streaming: 0 10 Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1 Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12 Aug 1 18:14:15 htpc2 kernel: modifying (0) streaming state for 1 Aug 1 18:14:15 htpc2 kernel: data for streaming: 0 10 Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 1 Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 12 Aug 1 18:14:15 htpc2 kernel: usb 6-1: USB disconnect, address 6 Aug 1 18:14:15 htpc2 kernel: mt2060 I2C write failed Aug 1 18:14:15 htpc2 kernel: dvb-usb: could not submit URB no. 0 - get them all back Aug 1 18:14:15 htpc2 kernel: modifying (1) streaming state for 0 Aug 1 18:14:15 htpc2 kernel: data for streaming: 10 13 Aug 1 18:14:15 htpc2 kernel: dvb-usb: error while enabling fifo. Aug 1 18:14:15 htpc2 vdr: [23167] ERROR: can't set filter (pid=18, tid=4E, mask=FE): No such device Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19) Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19) Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b Aug 1 18:14:15 htpc2 kernel: ep 0 read error (status = -19) Aug 1 18:14:15 htpc2 kernel: I2C read failed on address b Aug 1 18:14:16 htpc2 kernel: ep 0 read error (status = -19) Aug 1 18:14:16 htpc2 kernel: I2C read failed on address b Aug 1 18:14:16 htpc2 vdr: [23168] frontend 3 lost lock on channel 1, tp 506 Aug 1 18:14:16 htpc2 kernel: ep 0 read error (status = -19) Aug 1 18:14:16 htpc2 kernel: I2C read failed on address b Aug 1 18:14:16 htpc2 vdr: [23168] frontend 3 regained lock on channel 1, tp 506 Aug 1 18:14:17 htpc2 kernel: ep 0 read error (status = -19) when loading the firrmware; Aug 1 00:01:16 htpc2 kernel: dib0700: loaded with support for 3 different device-types Aug 1 00:01:16 htpc2 kernel: FW GET_VERSION length: -32 Aug 1 00:01:16 htpc2 kernel: cold: 1 Aug 1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500 Dual DVB-T' in cold state, will try to load a firmware Aug 1 00:01:16 htpc2 kernel: b2c2-flexcop: found the stv0299 at i2c address: 0x68 Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 0 (ST STV0299 DVB-S)... Aug 1 00:01:16 htpc2 kernel: b2c2-flexcop: initialization of 'Sky2PC/SkyStar 2 DVB-S' at the 'PCI' bus controlled by a 'FlexCopIIb' complete Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.0[A] -> GSI 19 (level, low) -> IRQ 18 Aug 1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T [card=18,autodetected] Aug 1 00:01:16 htpc2 kernel: TV tuner 4 at 0x1fe, Radio tuner -1 at 0x1fe Aug 1 00:01:16 htpc2 kernel: dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw' Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: Hauppauge model 90002, rev C176, serial# 47706 Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: MAC address is 00-0D-FE-00-BA-5A Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: tuner model is Thompson DTT7592 (idx 76, type 4) Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: TV standards ATSC/DVB Digital (eeprom 0x80) Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: audio processor is None (idx 0) Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: decoder processor is CX882 (idx 25) Aug 1 00:01:16 htpc2 kernel: tveeprom 2-0050: has no radio, has IR receiver, has no IR transmitter Aug 1 00:01:16 htpc2 kernel: cx88[0]: hauppauge eeprom: model=90002 Aug 1 00:01:16 htpc2 kernel: input: cx88 IR (Hauppauge Nova-T DVB-T as /class/input/input3 Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: found at 0000:00:08.0, rev: 5, irq: 18, latency: 32, mmio: 0xea000000 Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: registered device video0 [v4l2] Aug 1 00:01:16 htpc2 kernel: cx88[0]/0: registered device vbi0 Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x 8802 Driver Manager Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:08.2[A] -> GSI 19 (level, low) -> IRQ 18 Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: found at 0000:00:08.2, rev: 5, irq: 18, latency: 32, mmio: 0xeb000000 Aug 1 00:01:16 htpc2 kernel: dib0700: firmware started successfully. Aug 1 00:01:16 htpc2 kernel: cx2388x dvb driver version 0.0.6 loaded Aug 1 00:01:16 htpc2 kernel: cx8802_register_driver() ->registering driver type=dvb access=shared Aug 1 00:01:16 htpc2 kernel: CORE cx88[0]: subsystem: 0070:9002, board: Hauppauge Nova-T DVB-T [card=18] Aug 1 00:01:16 htpc2 kernel: cx88[0]/2: cx2388x based dvb card Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (cx88[0]) Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 1 (Conexant CX22702 DVB-T)... Aug 1 00:01:16 htpc2 kernel: dvb-usb: found a 'Hauppauge Nova-T 500 Dual DVB-T' in warm state. Aug 1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T) Aug 1 00:01:16 htpc2 kernel: I2C read failed on address b Aug 1 00:01:16 htpc2 kernel: I2C read failed on address a Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 2 (DiBcom 3000MC/P)... Aug 1 00:01:16 htpc2 kernel: ACPI: PCI Interrupt 0000:00:11.5[C] -> Link [ALKC] -> GSI 22 (level, low) -> IRQ 22 Aug 1 00:01:16 htpc2 kernel: PCI: Setting latency timer of device 0000:00:11.5 to 64 Aug 1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 = 1204) Aug 1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 125 Aug 1 00:01:16 htpc2 kernel: dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. Aug 1 00:01:16 htpc2 kernel: DVB: registering new adapter (Hauppauge Nova-T 500 Dual DVB-T) Aug 1 00:01:16 htpc2 kernel: DVB: registering frontend 3 (DiBcom 3000MC/P)... Aug 1 00:01:16 htpc2 kernel: MT2060: successfully identified (IF1 = 1229) Aug 1 00:01:16 htpc2 kernel: MT2060: calibration was successful: 135 Aug 1 00:01:16 htpc2 kernel: dvb-usb: Hauppauge Nova-T 500 Dual DVB-T successfully initialized and connected. Aug 1 00:01:16 htpc2 kernel: usbcore: registered new interface driver dvb_usb_dib0700 -- Torgeir Veimo |
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
