Hej all, I'm new to this list and subscribed because I am trying to bring my TwinHan MagicBox VP7041 USB to work and I'm having troubles... But first let me say thank you to everybody spending his ressource to this project!! Here is my case: I try to make kaffeine or xine working with my DVB-T USB device on Debian Etch. Before I switched finally to Linux some days ago, I had a Windows XP running on another partition with the TwinHan-Software running satisfying. OK, there were some drop-outs, but the quality was OK and the channel scanning worked completely. I write this to document the hardware and the field intesity are OK. I installed dvb-utils and kaffeine, downloaded the firmware and copied it to /lib/firmware. The box is recongnized an the drivers are loaded: from syslog: Aug 2 20:17:00 localhost kernel: usb 1-2: new full speed USB device using uhci_hcd and address 7 Aug 2 20:17:00 localhost kernel: usb 1-2: configuration #1 chosen from 1 choiceAug 2 20:17:00 localhost kernel: dvb-usb: found a 'TwinhanDTV USB-Ter USB1.1 / Magic Box I / HAMA USB1.1 DVB-T device' in warm state. Aug 2 20:17:00 localhost kernel: dvb-usb: will use the device's hardware PID filter (table count: 16). Aug 2 20:17:00 localhost kernel: DVB: registering new adapter (TwinhanDTV USB-Ter USB1.1 / Magic Box I / HAMA USB1.1 DVB-T device). nl-lt-boris:~# lsusb Bus 002 Device 001: ID 0000:0000 Bus 001 Device 002: ID 1822:3202 Twinhan VisionDTV USB-Ter/HAMA USB DVB-T device warm Bus 001 Device 001: ID 0000:0000 No I try to scan for channels: boris@nl-lt-boris:~$ scan /usr/share/doc/dvb-utils/examples/scan/dvb-t/de-Kiel > channels.conf scanning /usr/share/doc/dvb-utils/examples/scan/dvb-t/de-Kiel using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 474000000 0 2 9 1 1 3 0 initial transponder 586000000 0 2 9 1 1 3 0 initial transponder 618000000 0 2 9 1 1 3 0 initial transponder 666000000 0 2 9 1 1 3 0 initial transponder 682000000 0 2 9 1 1 3 0 initial transponder 762000000 0 2 9 1 1 3 0 >>> >>> tune to: 474000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_AUTO:QAM_16:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE WARNING: >>> tuning failed!!! [SNIP - last message repeated a lot of times] ERROR: initial tuning failed dumping lists (0 services) Done. Also, dvdsnoop does not give out anything: nl-lt-boris:~# dvbsnoop -s pidscan dvbsnoop V1.4.00 -- http://dvbsnoop.sourceforge.net/ --------------------------------------------------------- Transponder PID-Scan... --------------------------------------------------------- So what can I do? I'm thankful for every hint! Boris _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
