Hello, Has anyone been able to get this device working under linux ? I am have some trouble with it. When I switch the device on, the correct modules get loaded (ttusb_dec and ttusbdecfe), firmware gets loaded and I do not get any weird messages, so far so good. dmesg gives me: [74969.803277] DVB: registering new adapter (DEC2540-t) [74969.803409] DVB: registering frontend 0 (TechnoTrend/Hauppauge DEC2000-t Frontend)... However when I run tzap, I get lines like this: status 00 | signal 0001 | snr 0000 | ber b7f8a858 | unc b7f8ab38 | status 1f | signal 0001 | snr 0000 | ber b7f8a858 | unc b7f8ab38 | FE_HAS_LOCK status 1f | signal 0001 | snr 0000 | ber b7f8a858 | unc b7f8ab38 | FE_HAS_LOCK The signal-field always reads 0001 and snr is always 0000. I would expect a much higher value for signal then 0001 isn't it ? I can get a channel list, so part of the driver must be working, but mplayer does not work. I use: mplayer dvb://"Nederland 1" -vo x11 The error message that mplayer gives me is: .... Playing dvb://Nederland 1. dvb_tune Freq: 618000000 ERROR IN SETTING DMX_FILTER 7011 for fd 4: ERRNO: 38ERROR, COULDN'T SET CHANNEL 0: Failed to open dvb://Nederland 1. I am using MPlayer 2:1.0~rc1-0ubuntu9.1 on ubuntu feisty (kernel 2.6.20), and with the latest v4l-dvb modules. Any help is appreciated. Kees Stoop. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
