Am Montag, den 23.07.2007, 00:07 +0400 schrieb Manu Abraham: > Hi all, > > On one of the devices that i am working upon, it has a bus control entity. ie > > The device looks like this > > The device consists of > > 1) a BUS Interface Unit > 2) on this bus Interface unit (BIU) there is one single physical I2C bus > 3) a built in MASTER demodulator > > > The I2C bus on the device is _not_ directly connected to any > peripherals such as demods and or tuners. > > The bus goes to a control unit where the bus is split into 2 based on > a control word sent to the Bus Control Unit (BCU) > > The split out bus goes out like this > > 1) goes to the MASTER tuner for the built in demodulator > 2) goes to a SLAVE demodulator, which has just one switchable I2C > output for the tuner > > ie , the configuration looks like 2, 2 way switches cascaded together, > when the MASTER and SLAVE demodulators are cascaded. > > Looking at the device and thinking a lot, i don't see how the control > can fit in as a part of the frontend at all, as the it has nothing to > do with the frontend, but just the BIU. > > Some thought that i have, at present go like this > > * register independant virtual buses for each device, on device > access, the relevant control word is appended to the BIU device > register. > > * have one bus alone, but add a control for the bus such that the > control can be initiated from some place, but as i explained, this > control is not on the frontend/demodulator but on the Host controller. > > I would like to hear comments people have on this, or better ideas if any. > > Thanks, > Manu Hi Manu, best open discussion concept since long, hardware is forcing. Hopefully brings some others back and leads out of ideology. Best Regards, Hermann _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
