Hi, Am Freitag, den 15.06.2007, 16:16 +0200 schrieb Werner Braun: > Peter, > > >[snip] > >> thanks for your reply. Here's what DMESG says when using card=112: > >[snip] > > >Hi Werner, > > >Just looking at the subject line; LR306 suggests an MSI TV at nywhere A/D. > >Try card=94. The Anywhere A/D appears to be distinct from the Anywhere > >Plus, Anywhere Master and the plain Anywhere. I don't know where > >DVB at nywhere fits in the lineup. > > Here's what DMESG says: > > saa7130/34: v4l2 driver version 0.2.14 loaded > saa7133[0]: found at 0000:02:0e.0, rev: 208, irq: 18, latency: 32, mmio: > 0xdd800000 > saa7133[0]: subsystem: 4e42:3306, board: LifeView FlyDVB-T Hybrid Cardbus > [card=94,insmod option] > saa7133[0]: board init: gpio is 210000 > saa7133[0]: i2c eeprom 00: 42 4e 06 33 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7133[0]: i2c eeprom 10: 00 00 62 08 ff 20 ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01 03 08 ff 01 ed ff ff ff ff > saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 05 01 01 16 32 15 ff ff ff ff > saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > tuner 1-004b: chip found @ 0x96 (saa7133[0]) > tuner 1-004b: setting tuner address to 61 > tuner 1-004b: type set to tda8290+75a > tuner 1-004b: setting tuner address to 61 > tuner 1-004b: type set to tda8290+75a > saa7133[0]: registered device video0 [v4l2] > saa7133[0]: registered device vbi0 > saa7133[0]: registered device radio0 > DVB: registering new adapter (saa7133[0]) > DVB: registering frontend 0 (Philips TDA10046H DVB-T)... > tda1004x: setting up plls for 48MHz sampling clock > tda1004x: timeout waiting for DSP ready > tda1004x: found firmware revision 0 -- invalid > tda1004x: trying to boot from eeprom > tda1004x: timeout waiting for DSP ready > tda1004x: found firmware revision 0 -- invalid > tda1004x: waiting for firmware upload... > tda1004x: found firmware revision 29 -- ok > tda827x_probe_version: could not read from tuner at addr: 0xc2 hm, that was recently introduced by Hartmut to improve it for those cards. http://linuxtv.org/hg/~hhackmann/v4l-dvb/rev/bc9a765d3bb4 Peter, does Hartmut's repo or the recent mercurial master still work for you? Might we have a hardware change now? Think no. http://linuxtv.org/pipermail/linux-dvb/2007-March/016823.html > > ... and now for W_SCAN/DMESG > > tda1004x: setting up plls for 48MHz sampling clock > tda1004x: timeout waiting for DSP ready > tda1004x: found firmware revision 80 -- invalid > tda1004x: trying to boot from eeprom > tda1004x: timeout waiting for DSP ready > tda1004x: found firmware revision 80 -- invalid > tda1004x: waiting for firmware upload... > tda1004x: timeout waiting for DSP ready > tda1004x: found firmware revision 80 -- invalid > tda1004x: firmware upload failed > > ... so apparently no avail. > > the 4e42:3306 subvendor id is stated for card=55, so I reckon, this might be > the best bet. No, it has 4e42:0306. Also these have different tuners for analog and DVB. You might wait for a comment from Hartmut. > I've browsed through the old MSI threads - is there anything known about the > usage of frequency offsets (the 167 trick) in Germany, especially > Berlin-Brandenburg region? No, not reported. Your tuner is not oparable this way, the probe failed. Either it is still some loadorder/timing problem or the hardware changed. You might try to use analog TV first and things like "modprobe saa7134-alsa", "modprobe -vr saa7134-dvb" and then load it again. Does analog still work? You might do a cold boot first, 30 seconds no power connected and then try only with card=94. Cheers, Hermann _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
