>> >> I've tried quite a few things before bothering you here, I even stripped >>the >> firmware out of the driver on the Vivanco web side instead of using >> TDA10046Lifeview, but no avail, so I'm somewhat clueless at the moment and >> hoping that somebody here can help me out. >> >Hi, >Werner, did you try with card=112? >You are missing the i2c_gate functionality for tuning. >Cheers, >Hermann Hermann, thanks for your reply. Here's what DMESG says when using card=112: saa7130/34: v4l2 driver version 0.2.14 loaded saa7133[0]: found at 0000:02:0e.0, rev: 208, irq: 18, latency: 32, mmio: 0xdd800000 saa7133[0]: subsystem: 4e42:3306, board: ASUSTeK P7131 Hybrid [card=112,insmod option] saa7133[0]: board init: gpio is 210000 input: saa7134 IR (ASUSTeK P7131 Hybri as /class/input/input7 saa7133[0]: i2c eeprom 00: 42 4e 06 33 54 20 1c 00 43 43 a9 1c 55 d2 b2 92 saa7133[0]: i2c eeprom 10: 00 00 62 08 ff 20 ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 20: 01 40 01 03 03 01 01 03 08 ff 01 ed ff ff ff ff saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 40: ff 21 00 c2 96 10 05 01 01 16 32 15 ff ff ff ff saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff tuner 1-004b: chip found @ 0x96 (saa7133[0]) tuner 0x4b: Configuration acknowledged tuner 1-004b: setting tuner address to 61 tuner 1-004b: type set to tda8290+75a saa7133[0]: registered device video0 [v4l2] saa7133[0]: registered device vbi0 saa7133[0]: registered device radio0 DVB: registering new adapter (saa7133[0]). DVB: registering frontend 0 (Philips TDA10046H DVB-T)... tda1004x: setting up plls for 48MHz sampling clock tda1004x: timeout waiting for DSP ready tda1004x: found firmware revision 0 -- invalid tda1004x: trying to boot from eeprom tda1004x: timeout waiting for DSP ready tda1004x: found firmware revision 0 -- invalid tda1004x: waiting for firmware upload... tda1004x: found firmware revision 29 -- ok ... and now W_SCAN: tda1004x: setting up plls for 48MHz sampling clock tda1004x: found firmware revision ff -- invalid tda1004x: trying to boot from eeprom tda1004x: found firmware revision ff -- invalid tda1004x: waiting for firmware upload... tda1004x: Error during firmware upload tda1004x: found firmware revision ff -- invalid tda1004x: firmware upload failed saa7133[0]/dvb: could not access tda8290 I2C gate saa7133[0]/dvb: could not access tda8290 at addr: 0x96 saa7133[0]/dvb: could not access tda8290 I2C gate tda827xa_set_params: could not write to tuner at addr: 0xc2 saa7133[0]/dvb: could not access tda8290 I2C gate saa7133[0]/dvb: could not access tda8290 at addr: 0x96 saa7133[0]/dvb: could not access tda8290 I2C gate Note, that I am using the same FW file as the last time. Any further clue on behalf of yours? Could you elaborate on the i2c_gate thing? TIA & best regards Werner _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
