--- Markus Rechberger <mrechberger@xxxxxxxxx> wrote: > Hi, Hi Markus, > Regarding the firmward I have a few considerations (which are no big issues) > > * the first device reset request is missing in the firmware, which > means if that firmware will be used with other devices it wouldn't be > possible to reload the base firmware The firmware I attached is not a complete replacement for the original firmware. It should replace only the 7MHz (xc3028_DTV7_2633.i2c.fw) for Australia. The base firmware (xc3028_init0.i2c.fw) needs to be loaded first. > * regarding the different offset I consider a firmware upgrade > (there's an internal versionnumber for the firmware binaries, the > second version of the firmware could contain the offsets for the > different firmwares) Do you know of anyone else in the world on 7MHz who's had success with the 2750000 offset? We could certainly include the offset in the firmware. I'll need to check that the v2 firmware will work with the board. Even with the adjusted offset there are still some frequencies which do not map to the same tuning values as used by windows. > I'll add the fixed input frequency asap. Would you be able to place a #define around this specific for Australia - at least until we can figure out a better way to deal with it? I'm concerned that this may not work in other parts of the world. Regards, Roger. Send instant messages to your online friends http://au.messenger.yahoo.com _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
