I installed hopefully all necessary drivers and firmware for a DIBcom 3000p DVB-T device on OpenSuse 10.2 system with 2.6.18 Kernel dmesg says registered and looks fine for the hardware : dvb-usb: found a 'DiBcom USB2.0 DVB-T reference design (MOD3000P)' in cold state, will try to load a firmware dvb-usb: downloading firmware from file 'dvb-usb-dibusb-6.0.0.8.fw' usbcore: registered new driver dvb_usb_dibusb_mc dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. dvb-usb: found a 'DiBcom USB2.0 DVB-T reference design (MOD3000P)' in warm state. dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. dvb-usb: schedule remote query interval to 150 msecs. dvb-usb: DiBcom USB2.0 DVB-T reference design (MOD3000P) successfully initialized and connected. saa7146: register extension 'dvb'. 1. dmesg accepts the device including firmware 2. dvb-t works without any problem on XP , therefore no problem with the antenna. 3. the directory dev/adapter0 ... is there 4. starting kaffeine even notice the BiBcom 3000p 5. dvbscan scans with the result tuning failed 6. I checked the local channel list de-koeln-bonn , de-ruhrgebiet and compared it with the local definitions , seems to be ok 7. tzap even don´t give any result , always in status 0000 My triel ends with no result from dvbscan I use the local definition from de-Ruhrgebiet for the channel definition. Do I have all necessary drivers installed for the Kernel ? Are there any problems with drivers ? What can I do to test more ? _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
