Hi, Sergi Castaño Elias schrieb: > Hi all, > > Recently I've reinstalled my system with gentoo 2006.1 with kernel > version 2.6.19-gentoo-r5 using v4l-dvb installed following the link > CVS/Mercurial at linuxtv.org. > > When I try to load dvb module (saa7134-dvb) I get: > > genpkt v4l-dvb # modprobe saa7134-dvb > FATAL: Error inserting saa7134_dvb > (/lib/modules/2.6.19-gentoo-r5/v4l-dvb/video/saa7134/saa7134-dvb.ko): > Unknown symbol in module, or unknown parameter (see dmesg) > > Looking at dmesg output: > > Linux video capture interface: v2.00 > saa7130/34: v4l2 driver version 0.2.14 loaded > saa7134[0]: found at 0000:01:09.0, rev: 1, irq: 21, latency: 32, mmio: > 0xe1001000 > saa7134[0]: subsystem: 11bd:002d, board: Pinnacle PCTV 300i DVB-T + > PAL [card=50,autodetected] > saa7134[0]: board init: gpio is c80e000 > saa7134[0]: i2c eeprom 00: bd 11 2d 00 f8 f8 1c 00 43 43 a9 1c 55 d2 b2 92 > saa7134[0]: i2c eeprom 10: 00 f0 04 04 ff 20 ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 20: 01 40 01 02 03 ff 03 01 08 ff 00 25 ff ff ff ff > saa7134[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 40: ff 16 00 c0 86 3c 01 01 ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 60: 0c 22 17 44 03 1e 54 5e ff ff ff ff ff ff ff ff > saa7134[0]: i2c eeprom 70: 00 30 8d 18 b2 ad ff ff 74 7c ff ff ff ff ff ff > tuner 0-0043: chip found @ 0x86 (saa7134[0]) > tda9887 0-0043: tda988[5/6/7] found @ 0x43 (tuner) > tuner 0-0060: Chip ID is not zero. It is not a TEA5767 > tuner 0-0060: chip found @ 0xc0 (saa7134[0]) > tuner 0-0060: microtune: companycode=3cbf part=42 rev=22 > tuner 0-0060: microtune MT2050 found, OK > tuner 0-0060: microtune: companycode=3cbf part=42 rev=22 > tuner 0-0060: microtune MT2050 found, OK > saa7134[0]: registered device video0 [v4l2] > saa7134[0]: registered device vbi0 > saa7134_dvb: disagrees about version of symbol dvb_pll_tdhu2 > saa7134_dvb: Unknown symbol dvb_pll_tdhu2 > saa7134_dvb: disagrees about version of symbol dvb_pll_philips_td1316 > saa7134_dvb: Unknown symbol dvb_pll_philips_td1316 > saa7134_dvb: disagrees about version of symbol dvb_pll_tuv1236d > saa7134_dvb: Unknown symbol dvb_pll_tuv1236d > saa7134_dvb: disagrees about version of symbol tda10046_attach > saa7134_dvb: Unknown symbol tda10046_attach > saa7134_dvb: disagrees about version of symbol dvb_pll_configure > saa7134_dvb: Unknown symbol dvb_pll_configure > saa7134_dvb: disagrees about version of symbol dvb_pll_tdhu2 > saa7134_dvb: Unknown symbol dvb_pll_tdhu2 > saa7134_dvb: disagrees about version of symbol dvb_pll_philips_td1316 > saa7134_dvb: Unknown symbol dvb_pll_philips_td1316 > saa7134_dvb: disagrees about version of symbol dvb_pll_tuv1236d > saa7134_dvb: Unknown symbol dvb_pll_tuv1236d > saa7134_dvb: disagrees about version of symbol tda10046_attach > saa7134_dvb: Unknown symbol tda10046_attach > saa7134_dvb: disagrees about version of symbol dvb_pll_configure > saa7134_dvb: Unknown symbol dvb_pll_configure > > I don't know what I have done wrong. Perhaps missing dvb support at > kernel? > > Thanks everyone and sorry my poor english. > This occurs when you have a mixture of old- and new kernel modules. before you load the new modules after make install, you need to either do make rmmod or reboot the system. Good luck Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
