Hi, Kevin KevinLuX schrieb: > >> Hi, Kevin >> > Hi Harmut > >>> Few weeks ago, i modified the driver to support the LNA on this card. >>> So can you please try the recent version of the driver? You might >>> set the option debug=1 for the modules tuner and tda827x. >>> >>> Another possible cause is that many drivers ignore the channel >>> parameters while the tda10046 doesn't. You can set all to auto >>> except bandwidth. >>> >>> Best regards >>> Hartmut > i've installed new driver from mercurial this morning. > Then loaded modules tuner and tda827x with debug=1. > On modules loading this is kernel output > > tuner 2-004b: chip at addr 4b is a tda8290 > tuner 2-004b: Setting mode_mask to 0x0e > tuner 2-004b: chip found @ 0x96 (saa7133[0]) > tuner 2-004b: Calling set_type_addr for type=54, addr=0xff, mode=0x04, > config=0x01 > tuner 2-004b: set addr for type -1 > tuner 2-004b: defining GPIO callback > tuner 2-004b: tuner 0x4b: called during i2c_client register by adapter's > attach_inform > tuner 2-004b: defining GPIO callback > tuner 2-004b: setting tuner address to 61 > tuner 2-004b: type set to tda8290+75a > tuner 2-004b: saa7133[0] tuner I2C addr 0x96 with type 54 used for 0x0e > tda827x: tda827x_attach: > tda827x: tda827xa tuner found > DVB: registering new adapter (saa7133[0]). > DVB: registering frontend 0 (Philips TDA10046H DVB-T)... > > Later as you said i've try to scan on differnt settings particulary > > T 482000000 8MHz AUTO AUTO AUTO AUTO AUTO NONE > T 506000000 8MHz AUTO AUTO AUTO AUTO AUTO NONE > > During scan kernel output is : > > tda1004x: setting up plls for 48MHz sampling clock > tda1004x: found firmware revision 20 -- ok > tda827x: tda8275a AGC2 gain is: 10 > tda827x: tda8275a AGC2 gain is: 10 > tda827x: tda8275a AGC2 gain is: 10 ...... > > and this last message is continuely repeated during scan > > Result is : > Filter timoet for frequency 506 and channels from 482 ( and other > frequencies) > > With w_scan, i'm also able to see many others channels unfortunately > xine give me a message : > input_dvb: ERROR: Trying to get lock... > > kaffeine with its scan, show me only few channels (20 on 70), probably > because it find during scan more noise than good quality signal on some > channel > and unfortunately i can't use channels.conf from scan because it's not > compatible with kaff. > > Thanks > Best Regards > You log shows me 2 things: - you seem to have a very low antenna energy (or there is something wrong with my LNA handler. I don't have such a card, so i can't test) - You should download the firmware from Lifeview. It is more recent (2.9) and locks better on bad signals. In my personal repository http://linuxtv.org/hg/~hhackmann/v4l-dvb there is a bug fix which might affect your card as well. I originally considered it minor but this seems not to be the case. Can you please check this before we continue? Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
