Re: Nexus-S Oops when used on a 3.3-volt bus

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



I enabled debug mode in the stv0299 module and get the following:

Feb 23 12:52:02 corbin2 kernel: stv0299: stv0299: init chip
Feb 23 12:52:02 corbin2 kernel: stv0299: stv0299_wait_diseqc_idle
Feb 23 12:52:02 corbin2 kernel: stv0299: stv0299_send_diseqc_msg
Feb 23 12:52:02 corbin2 kernel: stv0299: stv0299_wait_diseqc_idle
Feb 23 12:52:02 corbin2 kernel: stv0299: stv0299_readreg: readreg error (reg == 0x0a, ret == -1)
Feb 23 12:52:03 corbin2 last message repeated 2 times
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_wait_diseqc_idle: timeout!!
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_set_frontend : FE_SET_FRONTEND
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_readreg: readreg error (reg == 0x0c, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x0c, val == 0x01, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x05, val == 0xb5, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x05, val == 0x35, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_set_FEC
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x31, val == 0x10, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x13, val == 0xb6, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x14, val == 0x53, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x1f, val == 0x3a, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x20, val == 0x2e, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x21, val == 0x90, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x22, val == 0x00, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_writeregI: writereg error (reg == 0x23, val == 0x00, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_readreg: readreg error (reg == 0x18, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_readreg: readreg error (reg == 0x1b, ret == -1)
Feb 23 12:52:03 corbin2 kernel: stv0299: stv0299_read_status : FE_READ_STATUS : VSTATUS: 0x00

This is 2.6.18 kernel running linux-dvb from 01/16/07.

- Mark.

On 2/23/07, Mark Buechler <mark.buechler@xxxxxxxxx> wrote:
I recently put together a system which consists entirely of 3.3-volt PCI 2.3 slots. All modules load successfully and recognize my Nexus. I can do an femon without issue. However, when tuning the card I get an oops. Can anyone point me in the right direction? The Nexus is keyed for 3.3-volt PCI, is it not compatible? Am I barking up the wrong tree here?

BUG: unable to handle kernel NULL pointer dereference at virtual address 00000001
 printing eip:
00000001
*pde = 00000000
Oops: 0000 [#1]
SMP
Modules linked in: ir_common compat_ioctl32 btcx_risc binfmt_misc nfs nfsd exportfs lockd nfs_acl sunrpc ppdev parport_pc lp parport ipv6 sg aic7xxx scsi_transport_spi pcnet32 af_packet lnbp21 stv0299 ivtv wm8775 cx25840 saa7115 msp3400 dvb_usb_gp8psk dvb_usb tuner joydev dvb_pll dvb_ttpci dvb_core psmouse mousedev serio_raw saa7146_vv tsdev evdev i2c_algo_bit video_buf saa7146 cx2341x ttpci_eeprom tveeprom videodev v4l2_common v4l1_compat 8250_pnp ibmphp floppy pcspkr rtc e100 mii ibmasm dm_round_robin dm_multipath ext3 jbd mbcache dm_mirror dm_snapshot multipath raid10 raid1 raid0 linear md_mod sd_mod ide_cd cdrom generic qla2xxx firmware_class scsi_transport_fc acenic scsi_mod ehci_hcd shpchp pci_hotplug ohci_hcd serverworks usbcore ide_core i2c_piix4 i2c_core thermal processor fan unix dm_mod
CPU:    1
EIP:    0060:[<00000001>]    Not tainted VLI
EFLAGS: 00010246   (2.6.18-4-686-smp #2)
EIP is at 0x1
eax: efe9625c   ebx: 80046f45   ecx: 80046f45   edx: ec9c2680
esi: efe9625c   edi: 00000004   ebp: ec613ec8   esp: ec613eb0
ds: 007b   es: 007b   ss: 0068
Process dvbscan_na (pid: 13560, ti=ec612000 task=ecf0a570 task.ti=ec612000)
Stack: f0dae109 ec613ec8 ec9c2680 efe9625c 00000002 00000000 00000001 00000002
       ec613f30 ec613f2c 00000000 00000000 b5d4567f 00000670 c01223fa ec613f10
       00d851f0 ec613f10 00000009 dfb40570 dfb40570 b5d4a7ae 00000670 0000487c
Call Trace:
 [<f0dae109>] dvb_usercopy+0xa3/0x117 [dvb_core]
 [<c01223fa>] getnstimeofday+0x30/0xb9
 [<c012e9ed>] lock_hrtimer_base+0x19/0x35
 [<c012ea86>] hrtimer_try_to_cancel+0x33/0x48
 [<c012eaa9>] hrtimer_cancel+0xe/0x14
 [<f0dae1b7>] dvb_generic_ioctl+0x3a/0x44 [dvb_core]
 [<c016ca34>] do_ioctl+0x64/0x6d
 [<c016ca8d>] vfs_ioctl+0x50/0x279
 [<c0111f9d>] do_page_fault+0xdd/0x571
 [<c016cd13>] sys_ioctl+0x5d/0x6e
 [<c0102bab>] syscall_call+0x7/0xb
Code:  Bad EIP value.
EIP: [<00000001>] 0x1 SS:ESP 0068:ec613eb0
 <1>BUG: unable to handle kernel paging request at virtual address 30303030
 printing eip:
30303030
*pde = 00000000
Oops: 0000 [#2]
SMP
Modules linked in: ir_common compat_ioctl32 btcx_risc binfmt_misc nfs nfsd exportfs lockd nfs_acl sunrpc ppdev parport_pc lp parport ipv6 sg aic7xxx scsi_transport_spi pcnet32 af_packet lnbp21 stv0299 ivtv wm8775 cx25840 saa7115 msp3400 dvb_usb_gp8psk dvb_usb tuner joydev dvb_pll dvb_ttpci dvb_core psmouse mousedev serio_raw saa7146_vv tsdev evdev i2c_algo_bit video_buf saa7146 cx2341x ttpci_eeprom tveeprom videodev v4l2_common v4l1_compat 8250_pnp ibmphp floppy pcspkr rtc e100 mii ibmasm dm_round_robin dm_multipath ext3 jbd mbcache dm_mirror dm_snapshot multipath raid10 raid1 raid0 linear md_mod sd_mod ide_cd cdrom generic qla2xxx firmware_class scsi_transport_fc acenic scsi_mod ehci_hcd shpchp pci_hotplug ohci_hcd serverworks usbcore ide_core i2c_piix4 i2c_core thermal processor fan unix dm_mod
CPU:    1
EIP:    0060:[<30303030>]    Not tainted VLI
EFLAGS: 00010246   (2.6.18-4-686-smp #2)
EIP is at 0x30303030
eax: effeabe8   ebx: effeabe8   ecx: 30303030   edx: 00000000
esi: ec9c2680   edi: effeaddc   ebp: efe9625c   esp: ec613d58
ds: 007b   es: 007b   ss: 0068
Process dvbscan_na (pid: 13560, ti=ec612000 task=ecf0a570 task.ti=ec612000)
Stack: f0db46c2 00000000 efe96384 00000008 ec9c2680 efe9625c ef824c6c c015ca48
       00000000 00000000 dff547c0 ec9c2680 ed005b40 00000000 ed005b40 c015a1d7
       00000000 00000001 dfd092c0 00000000 c011bf2f 00000000 00000000 0000000c
Call Trace:
 [<f0db46c2>] dvb_frontend_release+0x41/0x67 [dvb_core]
 [<c015ca48>] __fput+0x93/0x175
 [<c015a1d7>] filp_close+0x3e/0x62
 [<c011bf2f>] put_files_struct+0xa8/0xc3
 [<c011d01a>] do_exit+0x146/0x8b2
 [<c0103677>] apic_timer_interrupt+0x1f/0x24
 [<c01040a1>] do_trap+0x0/0xb5
 [<c0112139>] do_page_fault+0x279/0x571
 [<c0111ec0>] do_page_fault+0x0/0x571
 [<c0103729>] error_code+0x39/0x40
 [<f0dae109>] dvb_usercopy+0xa3/0x117 [dvb_core]
 [<c01223fa>] getnstimeofday+0x30/0xb9
 [<c012e9ed>] lock_hrtimer_base+0x19/0x35
 [<c012ea86>] hrtimer_try_to_cancel+0x33/0x48
 [<c012eaa9>] hrtimer_cancel+0xe/0x14
 [<f0dae1b7>] dvb_generic_ioctl+0x3a/0x44 [dvb_core]
 [<c016ca34>] do_ioctl+0x64/0x6d
 [<c016ca8d>] vfs_ioctl+0x50/0x279
 [<c0111f9d>] do_page_fault+0xdd/0x571
 [<c016cd13>] sys_ioctl+0x5d/0x6e
 [<c0102bab>] syscall_call+0x7/0xb
Code:  Bad EIP value.
EIP: [<30303030>] 0x30303030 SS:ESP 0068:ec613d58
 <1>Fixing recursive fault but reboot is needed!

_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb

[Index of Archives]     [Linux Media]     [Video 4 Linux]     [Asterisk]     [Samba]     [Xorg]     [Xfree86]     [Linux USB]

  Powered by Linux