On Thu, 22 Feb 2007, Jeroen Asselman wrote:
> Hi.
>
> > How can one get debugging information from the CI-module, CAM and the
> > PC-card to see why the initialization fails?
>
> I added the following lines to my modprobe.conf for more debugging info:
> options dvb-core cam_debug=1,1 debug=1,1
> options budget-core debug=1,1
I added the following debug options to
/etc/modprobe.conf
options dvb-core cam_debug=1,1 debug=1,1
options budget-core debug=1,1
modprobe budget_av gives then these messages:
saa7146: register extension 'budget_av'.
ACPI: PCI Interrupt 0000:04:08.0[A] -> Link [LNKA] -> GSI 18 (level, low) -> IRQ 21
saa7146: found saa7146 @ mem f8ab4400 (revision 1, irq 21) (0x1894,0x0021).
saa7146 (0): dma buffer size 192512
DVB: registering new adapter (KNC1 DVB-C Plus).
adapter failed MAC signature check
encoded MAC from EEPROM was ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff:ff
budget_av: saa7113_init(): saa7113 detected and initializing
budget_av: saa7113_init(): saa7113 status=d0
saa7146_vv: saa7146 (0): registered device video1 [v4l2]
KNC1-0: MAC addr = 00:09:d6:6d:5c:c4
DVB: registering frontend 0 (Philips TDA10021 DVB-C)...
dvb_ca_en50221_init
budget-av: ci interface initialised.
dvb_ca_en50221_thread
Inserting the Conax CAM with the Conax card gives these messages:
budget-av: cam inserted B
budget_av: ciintf_slot_reset(): ciintf_slot_reset
dvb_ca adaptor 0: PC card did not respond :(
Removing it gives these messages:
budget_av: ciintf_slot_shutdown(): ciintf_slot_shutdown
budget-av: cam ejected 5
dvb_ca_en50221_slot_shutdown
budget_av: ciintf_slot_shutdown(): ciintf_slot_shutdown
Slot 0 shutdown
rmmod budget_av gives this message:
ACPI: PCI interrupt for device 0000:04:08.0 disabled
What can be learned from this?
Best regards, Tomas Lindén_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
