The patch for TDA10023 is working fine, thank you. Best regards Vasi ----- Original Message ---- From: e9hack <e9hack@xxxxxxxxxxxxxx> To: linux-dvb@xxxxxxxxxxx Sent: Thursday, February 15, 2007 5:49:50 PM Subject: Re: Problem with KNC1 DVB-C card Vasile Farcas wrote: > Hello > I have a problem with a KNC1 DVB-C card, first was not recognized by the system, and on a lspci -vv reported : > > 00:0b.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01) > Subsystem: KNC One: Unknown device 0022 > Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- > Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR- > Latency: 64 (3750ns min, 9500ns max) > Interrupt: pin A routed to IRQ 11 > Region 0: Memory at fae00000 (32-bit, non-prefetchable) [size=512] > > Then I defined susbsystem 22 in budget-av.c, and the board appeared in /dev/dvb. Unfortunately, the result on scandvb is still the same: > > This is a new card with the TDA10023. You should try the patch from this mail: http://linuxtv.org/pipermail/linux-dvb/2007-February/015886.html - Hartmut _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb ____________________________________________________________________________________ The fish are biting. Get more visitors on your site using Yahoo! Search Marketing. http://searchmarketing.yahoo.com/arp/sponsoredsearch_v2.php _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
