Hello
I have a problem with a KNC1 DVB-C card, first was not recognized by the system, and on a lspci -vv reported :
00:0b.0 Multimedia controller: Philips Semiconductors SAA7146 (rev 01)
Subsystem: KNC One: Unknown device 0022
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B-
Status: Cap- 66Mhz- UDF- FastB2B+ ParErr- DEVSEL=medium >TAbort- <TAbort- <MAbort- >SERR- <PERR-
Latency: 64 (3750ns min, 9500ns max)
Interrupt: pin A routed to IRQ 11
Region 0: Memory at fae00000 (32-bit, non-prefetchable) [size=512]
Then I defined susbsystem 22 in budget-av.c, and the board appeared in /dev/dvb. Unfortunately, the result on scandvb is still the same:
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
initial transponder 306000000 6900000 0 3
>>> tune to: 306000000:INVERSION_AUTO:6900000:FEC_NONE:QAM_64
WARNING: >>> tuning failed!!!
>>> tune to: 306000000:INVERSION_AUTO:6900000:FEC_NONE:QAM_64 (tuning failed)
WARNING: >>> tuning failed!!!
Signal presence was tested before.
What have i done wrong?
Thanks
Vasi
____________________________________________________________________________________
Bored stiff? Loosen up...
Download and play hundreds of games for free on Yahoo! Games.
http://games.yahoo.com/games/front
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
