Sam Bakara wrote: > Greetz, > > I have Ubuntu-Edgy kernel 2.6.17-10-generic > USB Device: MSI MegaSky 580 id 5580 > > Compiled & Installed latest drivers and loaded module as follows: > > [17179598.452000] dvb-usb: downloading firmware from file > 'dvb-usb-megasky-02.fw' > [17179599.064000] dvb_usb_m920x: probe of 5-5:1.0 failed with error 64 > [17179599.064000] usbcore: registered new driver usb-storage > [17179599.068000] usbcore: registered new driver dvb_usb_m920x > [17179599.172000] usb 5-5: USB disconnect, address 4 > [17179599.412000] usb 5-5: new high speed USB device using ehci_hcd and > address 6 > [17179599.556000] usb 5-5: configuration #1 chosen from 1 choice > [17179599.556000] dvb-usb: found a 'MSI Mega Sky 580 DVB-T USB2.0' in > warm state. > [17179599.556000] dvb-usb: will pass the complete MPEG2 transport stream > to the software demuxer. > [17179599.704000] dvb-usb: schedule remote query interval to 100 msecs. > [17179599.704000] dvb-usb: MSI Mega Sky 580 DVB-T USB2.0 successfully > initialized and connected. > > Problem: > Using Kaffeine to scan for channels in Australia, cannot lock lock onto > channels. > > I can see it trying, the USB device LED lights up while scanning and I > can see SNR up to 75% while scanning, but no lock on. > > Any help would be appreciated. Sam, It looks as though the mt352 demod driver isnt loaded. Perhaps the dependencies were not correctly built. Please do "make distclean" in the v4l-dvb tree, then build and install all over again. Let us know if that helps. Cheers, Mike _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb