Hello, I have not been able yet to find a solution or indeed any other similar problem. This is my first post to this mailing list. I have four Nebula Electronics tuners: 1 PCI (NXT6000), 2 USB master (MT352) and 1 USB slave (MT352). They are all the DVB terrestrial versions. My AMD 32bit based PC is running Fedora Core 6.0. The antenna is chained through all the devices with the source going in to the slave device. All devices work perfectly except the slave which despite being recognised perferctly as far as I know does not work. I don't have Windows on the machine but I have been able to confirm that at least one of the master and the slave device work on a Intel based laptop running Nebula's software and drivers under Windows XP. I have attempted to capture from the device but the results are consitent with the dvbscan below, the problem is not just with scanning. It would be great if someone could point me in the right direction please. Many thanks. ==================== the kernel ---------------------------------------- uname -r 2.6.18-1.2868.fc6 ==================== ####################### the card being recognised ---------------------------------------- dmesg dvb-usb: found a 'Nebula Electronics uDigiTV DVB-T USB2.0)' in warm state. dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer. DVB: registering new adapter (Nebula Electronics uDigiTV DVB-T USB2.0)). DVB: registering frontend 1 (Zarlink MT352 DVB-T)... input: IR-receiver inside an USB DVB receiver as /class/input/input7 dvb-usb: schedule remote query interval to 1000 msecs. dvb-usb: Nebula Electronics uDigiTV DVB-T USB2.0) successfully initialized and connected. #################################################################### =========================================== there does not seem to be a signal when I attempt to tune --------------------------------------------------------------------------------------- dvbscan scanning /usr/share/dvb-apps/dvb-t/uk-CrystalPalace using '/dev/dvb/adapter1/frontend0' and '/dev/dvb/adapter1/demux0' initial transponder 505833333 0 3 9 1 0 0 0 >>> tune to: 505833333:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_3_4:FEC_AUTO:QAM_16:TRANSMISSION_MODE_2K:GUARD_INTERVAL_1_32:HIERARCHY_NONE WARNING: filter timeout pid 0x0011 WARNING: filter timeout pid 0x0000 WARNING: filter timeout pid 0x0010 dumping lists (0 services) Done. =========================================================================================================================== _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
