On 1/11/07, Giampiero Giancipoli <gianci@xxxxxxxx> wrote:
>I own a flyDVB-T card (saa7134) that is detected by current the kernel >(2.6.18 debian unstable for K7), but does not work when trying to scan for >dvb channels with 'es-Madrid'. >770000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_2_3:FEC_1_2:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_4:HIERARCHY_NONE Turn both FEC_2_3 to FEC_AUTO. Are you sure that the guard interval is 1/4? If the change above does not help you change it to 1/32.
I've changed those parameters an tried again, but no luck. Scanning report is similar: -- ./scan -v /temp/es-Madrid scanning /temp/es-Madrid using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0' initial transponder 618000000 0 9 9 3 1 0 0 initial transponder 706000000 0 9 9 3 1 0 0 initial transponder 770000000 0 9 9 3 1 0 0 initial transponder 810000000 0 9 9 3 1 0 0 initial transponder 834000000 0 9 9 3 1 0 0 initial transponder 842000000 0 9 9 3 1 0 0 initial transponder 850000000 0 9 9 3 1 0 0 initial transponder 858000000 0 9 9 3 1 0 0
tune to: 618000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_AUTO:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_32:HIERARCHY_NONE tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00
WARNING: >>> tuning failed!!!
tune to: 618000000:INVERSION_AUTO:BANDWIDTH_8_MHZ:FEC_AUTO:FEC_AUTO:QAM_64:TRANSMISSION_MODE_8K:GUARD_INTERVAL_1_32:HIERARCHY_NONE
(tuning failed)
tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00 tuning status == 0x00
WARNING: >>> tuning failed!!! ... --
>tda10046 part: > tda1004x: setting up plls for 48MHz sampling clock > tda1004x: found firmware revision 23 -- ok You may consider to upgrade the tda10046 firmware to revision 29.
Firmware on this card is in an eeprom, so I think that I cannot update it. I've tried to put dvb-fe-tda10046.fw file on /lib/firmware/, expecting that this file could override the eeprom one when system is running, but tda module loads always the eeprom firmware. Thanks
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
