Hello. As I remember for my little study of the existing linux code directory about b2c2 driver, PC-IDs of a PCI card are not used at this time for drivers for FlexCop: all frontend is tried when loading modules drivers. (you can understand this info: modules for hardware can be loaded succefully even hardware is not present, but it's not a problem at all for the present hardware) PCI-IDs is not the most important information: you need to know the version of the Flexcop chip, the demodulator chips (and less?: the tuner=pll). You can use debug parameter with insmod or modprobe to see more details. For example: "make unload sync /sbin/modprobe i2c-core /sbin/insmod ./dvb-core.ko #frontend_debug=1 /sbin/insmod ./dvb-pll.ko /sbin/insmod ./mt312.ko /sbin/insmod ./mt352.ko /sbin/insmod ./bcm3510.ko /sbin/insmod ./nxt200x.ko /sbin/insmod ./lgdt330x.ko /sbin/insmod ./stv0299.ko /sbin/insmod ./compat_ioctl32.ko /sbin/insmod ./v4l1-compat.ko /sbin/insmod ./v4l2-common.ko /sbin/insmod ./videodev.ko /sbin/insmod ./video-buf.ko /sbin/insmod ./stv0297_cs2.ko debug=1 ##debug:set debugging level (1=info,2=i2c,4=calc (|-able)). (int) /sbin/insmod ./b2c2-flexcop.ko debug=3 ##debug:set debug level (1=info,2=tuner,4=i2c,8=ts,16=sram,32=reg...) /sbin/insmod ./b2c2-flexcop-pci.ko ##debug:set debug level (1=info,2=regs,4=TS,8=irqdma (|-able)). (int) " " /sbin/insmod ./b2c2-flexcop.ko debug=3 " debug info and i2c messages.. (see sources) 1=info,2=i2c, 3=1+2 At soon, Yvan. Le Saturday 23 December 2006 11:55, Bernhard Huafbauer a écrit : > For the records: I have also shut down my system removed a > AVM Fritzcard, inserted this Skystar2 and booted. > > (If this occurs only in this combination a solution could be to > remove the old card, boot und shutdown one times and then > insert the Skystar2?) > > Regards > Bernhard > > Am Samstag, 23. Dezember 2006 09:51 schrieb Michael Joswig: .... _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb