Exact model: A16D
I've been reading several howto's on linuxt.org and other places but I can't get to any point.
This card has the following relevant chips:
- SAA7135HL decoder
- MT352 demodulator
- XC3018ACQ tuner
AFAIK, all of them are supported, but no one card has them together. However I don't know where start to merge these modules.
dmesg with saa7134 without parameters:
saa7130/34: v4l2 driver version 0.2.14 loaded
ACPI: PCI Interrupt 0000:00:0b.0[A] -> Link [LNKC] -> GSI 5 (level, low) -> IRQ 5
saa7133[0]: found at 0000:00: 0b.0, rev: 209, irq: 5, latency: 32, mmio: 0xdf001000
saa7133[0]: subsystem: 1461:f936, board: UNKNOWN/GENERIC [card=0,autodetected]
saa7133[0]: board init: gpio is effffff
saa7133[0]: i2c eeprom 00: 61 14 36 f9 00 00 00 00 00 00 00 00 00 00 00 00
saa7133[0]: i2c eeprom 10: ff ff ff ff ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 40 01 02 02 01 01 00 08 ff 00 0e ff ff ff ff
saa7133[0]: i2c eeprom 30: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 40: ff 65 00 ff c2 1e ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
I've notice that if I pass card=46 to the card, I can execute tvtime-scanner, although all tuners I've tried fail tuning analog channels.
If I pass card=85 to the card, it looks like if it loads fine dvb, but scan (from dvbapps) fails always. I suppose again is a trouble with the tuner, which I cannot identify correctly.
On both cases, I tried several (almost all of them) Philips tuners and tuner 71, with no result.
lspci:
00:0b.0 Multimedia controller: Philips Semiconductors SAA7133/SAA7135 Video Broadcast Decoder (rev d1)
lspci nv:
00:0b.0 0480: 1131:7133 (rev d1)
Subsystem: 1461:f936
Flags: bus master, medium devsel, latency 32, IRQ 5
Memory at df001000 (32-bit, non-prefetchable) [size=2K]
Capabilities: [40] Power Management version 2
System is debian Etch - kernel 2.6.17-2-686
Software: tvtime and kdetv for analog tv; kaffeine for dvb-t
So, how can I start for getting this card working (analog or dvb, at least one of them) ?
Thanks, and sorry about my poor english.
_______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
