Hartmut Hackmann ha scritto:
Hi, Folks
This patch should make make the Pinnacle 310i DVB-T working.
It is based on the patch by Pierluigi_Rolando and should apply
to the v4l-dvb repository at http://www.linuxtv.org of today.
I don't have this card, so i need you to test it.
The card should be fully working except remote control
if there is one.
I assume the radio is based on the tda8290, TDA8275a, hope
this is right. You still need to tune manually.
Please test whatever you can and report.
It works !!
Here my configuration :
Ubuntu 6.06 - Kernel Vanilla 2.6.18 - v4l-dvb from today 05 October 2006.
Here my step.
1- cd v4l dir
2- patch -p1 < pinnacle........patch
3- make all & make install
4- perl *path_to_v4l_dir*/linux/Documentation/dvb/get_dvb_firmware tda10046
5- cp
*path_to_v4l_dir*/linux/Documentation/dvb/get_dvb_firmware/dvb-fe-tda10046.fw
/lib/firmware
6- only for my personal reason i prefer to load manually the module so i
put in /etc/modprobe.d/blacklist the line: blacklist saa7134
7- reboot
On new session :
8- modprobe saa7134
------------ KERNEL MESSAGES -------------
Linux video capture interface: v2.00
saa7130/34: v4l2 driver version 0.2.14 loaded
OcACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
OACPI: PCI Interrupt 0000:01:09.0[A] -> Link [APC2] -> GSI 17 (level,
high) -> IRQ 21
saa7133[0]: found at 0000:01:09.0, rev: 208, irq: 21, latency: 32, mmio:
0xdc100000
saa7133[0]: subsystem: 11bd:002f, board: Pinnacle PCTV 310i
[card=101,autodetected]
saa7133[0]: board init: gpio is 600e000
saa7133[0]: i2c eeprom read error (err=-5)
tuner 2-004b: chip found @ 0x96 (saa7133[0])
tuner 2-004b: setting tuner address to 61
tuner 2-004b: type set to tda8290+75a
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0
saa7134 ALSA driver for DMA sound loaded
saa7133[0]/alsa: saa7133[0] at 0xdc100000 irq 21 registered as card -1
----------END OF KERNEL MESSAGE --------------------
9- modprobe saa7134-dvb
----------KERNEL MESSAGES -------------------
DVB: registering new adapter (saa7133[0]).
DVB: registering frontend 0 (Philips TDA10046H DVB-T)...
----------END OF KERNEL MESSAGE -----------------
10- scan it-Milano
----------KERNEL MESSAGES -------------------
tda1004x: setting up plls for 48MHz sampling clock
tda1004x: found firmware revision 0 -- invalid
----------END OF KERNEL MESSAGE -----------------
output of scan programs : many stations :P
11- With kaffeine i try to rescan and view channels --> that's all ok!!
12- Analog work without specify card=77 options! Tvtime shows channels
without problems!
Sorry for my long report but i think that all details in a testing
procedure are very important!
Hope that's all is clear!!
Theres a remote....any chance to get it works??
_______________________________________________
linux-dvb mailing list
linux-dvb@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
