Robin Bowes wrote: > I see the same error: > > usb 5-7: new high speed USB device using ehci_hcd and address 14 > usb 5-7: configuration #1 chosen from 1 choice > dvb-usb: found a 'WideView WT-220U PenType Receiver (based on ZL353)' in > cold state, will try to load a firmware > dvb-usb: downloading firmware from file 'dvb-usb-wt220u-zl0353-01.fw' > usbcore: registered new driver dvb_usb_dtt200u > usb 5-7: USB disconnect, address 14 > dvb-usb: generic DVB-USB module successfully deinitialized and disconnected. > usb 5-7: new high speed USB device using ehci_hcd and address 15 > usb 5-7: configuration #1 chosen from 1 choice > dvb-usb: found a 'WideView WT-220U PenType Receiver (based on ZL353)' in > warm state. > dvb-usb: will use the device's hardware PID filter (table count: 15). > DVB: registering new adapter (WideView WT-220U PenType Receiver (based > on ZL353)). > DVB: registering frontend 0 (WideView USB DVB-T)... > input: IR-receiver inside an USB DVB receiver as /class/input/input8 > dvb-usb: schedule remote query interval to 300 msecs. > dvb-usb: WideView WT-220U PenType Receiver (based on ZL353) successfully > initialized and connected. > dvb-usb: recv bulk message failed: -110 > > > The thing is, this used to work. It's got broken in the course of an > upgrade over the last month or two. Perhaps I should regress to an > earlier kernel version? This is using FC5. R. _______________________________________________ linux-dvb mailing list linux-dvb@xxxxxxxxxxx http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
